Those are for the axle where the hex attaches...will not work for the cvd/cva.
http://www.amainhobbies.com/product_...t-w-Set-Screws
This one is cheaper.

Tower says my order for 2- 4.2's is processing, it won't be long now!

nice. did you order ballcups also?

Yep, I have RPM Ballcups and some proline tires ready to install.

nice. I hope you enjoy the car. It is pretty good right of the box.

If anyone is interested, I have ceramic diff and thrust sets for B4. 10.00 Shipped. 12 diff and 6 thrust, PM if you are interested.

Showed up today with Bug ready to race, no 2wd drivers today, had to race SC. Since it has warmed up, 2wds are scarce.

Dang! I hope that doesn't happen here on the "right coast" S.C.

Damn that would suck. 2 wheel buggy is always a for sure class around these parts.

PM sent. Need PP info to pay for them.

I dont know why you think the stock ball cups so so terribly bad. I myself use to run the RPM and noticed a lot of binding which isn't good, so I put the stock ball cups back on, and I must say I really like them.. Since the 5 months I have had them on I have only broke one; it was totally my fault too.

It has been said that the ball cups that come in the kit are garbage and are of a different quality then the ones you can purchase off the wall. RPM ball cups IMO are garbage, they either bind or pop off too easy. I would always run the grey Losi cups in the rear (thats where i had issues bending/breaking the AE cups) and the AE cups in the front.

http://www.amainhobbies.com/product_...al-Rebuild-Kit

Can this be used in the Associated diff and the MIP?
or just the mip diff?

[QUOTE=shagnat;12141998] have a few sets left.

Same parts. Will work with both.