Is anyone using the one piece engine mount and if so, does it create harmonic distortion?

Greg you have PM

Brock87 you have PM

Greg you have PM

i love to here from usa about people dropping cap at his club because of reliability promlems///
i was told x ray was copy of mtx4r and now i am told cap is copy of x ray if 4r was know good than why is it copied
mugen for ever
greg i am probably wrong again if so i apologize in advance i am covering my ass

I'm lucky to say that I really have not had any problem except leaking diff , but I got that fixed. I Also run composite diff gears. Got about 1 1/2 gallons on the 5 . The car is lightning quick!

front diff is a dam sh// of a thing to get apart/and get it back together was better on 4r

Why? Do you need to remove bulkheads?

I found changing over a front diff quicker on the 5 vs the 4, though it's more fiddly than doing one on a 4, but if can work the flicking out of the bearing carriers, it is faster.

Where could I see fukudas setup, every time I open his file it comes up as a blank setup sheet.

I had the same problem when I opened the PDF file on my iPad.

It worked ok on my Laptop.

Are you kidding me!? I'm using an iPad as well?. Has to be another way

Maybe there is a way around it but I'm unaware of a solution.

I have attached the setup file as a JPG file. See if that works.

Excellent! Thanks a lot occ

EVO-Workshop MTX-5 7075 T6 Hardcoated Chassis (EVO-MTX5-ET2401)




www.rcgoods.com