PM me your email address and I'll send you my Snowbirds set up.

Hey if anyone is interested I have 2 tc6.1 for sale. $360 shipped (nib). I know this prob isn't the right thread but sometimes if the deal is right it is hard to pass up. Anyway pm me if interested.

Just so there is no confusion these are 360/ea.

Thanks

Is this set up system any good?
I don't want to buy Hudy!
http://www.rc-mushroom.com/product_i...or-110-p-17192

And this one?
http://www.rc-mushroom.com/product_i...tation-p-13672
Anyone use this one or one like this?
Any experiences in using it?

And using is in combo with these?
http://www.rc-mushroom.com/product_i...ouring-p-21991

last week i got a virus on my computer when visiting rcmushroom, so havent checked your links, and i dont recommend anyone to visit mushroom now (unless you are surfing from a apple computer/device)

most setup systems do a good job, just buy the one that you feel fit your needs (colour/price)

In my opinion, use the setup system is not essential, i use it rarely to re-check my seetings, so you can use other tools to set ur car:

* Camber: camber gauge to onroad 1/10 scale y think
* Tweak : Check the thread "ask keven hebert" he explains how to check if your car is tweak or not

Perhaps is useful to check front toe, it depends on your money and options...So in conclusion, yes 3 Racing offers almost the same precision of hudy i think....

Best Regards.....

I've been using the setup station and really like it. It's Freaky how close this to to the Hudy system but at a fraction of the price. As far as Im concerned it's a great investment

READ HERE

Hi y'all.
Thanks for your input. I'm going for the 3 Racing setup tools.

One other, somewhat odd, question.
Does anyone know if the springs of the Corally RDX PHi'09 fit on the shocks of the TC6.1?

Im Getting back into touring car...

Anyone have a good starting setup for outdoor asphalt?.

Thanks

Rick, sorry for disturb, from the setup sheet, i saw your front wheel is -1 toe, is that mean toe in? beside of toe out, it's suppose to run toe out, am i right?
what effect will have if you make it toe in?

Hi guys, I'm looking at upgrading to a tc6 or 6.1, is there any real benefit of the 6.1 over the 6? Is there still a good parts supply for the 6?

Hi y'all,

Can the screws in the topdeck of the 6.1 be used for flex tuning?
Screws in stiffer, screws out more flex, and so on.
Which screws to do what with to accomplish what?

Any experience?

Or is the topdeck of this car not meant to be used that way?

And how about cutting the topdeck to get more flex to have more grip under low grip circumstances?
If an option, where to cut it? Dremel the material off that is in between the fork in the back?
Or in the front where there is a hole and cut the material out that's in front of that?

The blanc setup sheets have no option to fill in a category on topdeckflex.
And the manual doesn't say anything about it.

I saw the same thing. I have to think what he meant was 1 degree toe out. The rear indicates +3 degrees so I have to believe he meant negative to mean toe out not toe in the way the setup sheet diagram indicates.

If you look at the Arm Mount shims it gives you toe in on rear what her has referd to + toe so he must mean toe out -1 on the front.