R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
 
Search: Posts Made By: AZRC4Me
Showing results 1 to 25 of 500
Search took 0.05 seconds.
03-30-2016, 11:17 AM
Replies: 2
Views: 552
Posted By AZRC4Me

bump

bump
03-29-2016, 01:17 PM
Replies: 2
Views: 552
Posted By AZRC4Me

Bump.

Bump.
03-22-2016, 12:01 PM
Replies: 2
Views: 552
Posted By AZRC4Me

FS-Vintage European Kyosho Jacket

For Sale - worn once and not at a race, this Vintage European Kyosho jacket (size Medium) is basically brand new. Cannot be purchased state-side to my knowledge. Jacket is in perfect condition and...
11-09-2015, 01:52 PM
Replies: 2
Views: 657
Posted By AZRC4Me

SOLD.

SOLD.
11-08-2015, 03:32 PM
Replies: 2
Views: 657
Posted By AZRC4Me

HUDY Setup Tools For Sale

Selling both a setup station for 1/8 and 1/10 off road. Both are perfect. $300
1/8th setup station is part#-108856. Sorry couldn't post pics of the 1/10 setup station, part#-108905. Can txt or...
04-24-2015, 09:23 AM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

Biggest dynamic difference taller shocks and...

Biggest dynamic difference taller shocks and tower will give you is decreased shock shaft velocity. So you'll need to re-work your front shock package most likely with thinner oil, fewer and/or...
04-07-2015, 06:33 PM
Replies: 151
Views: 21,363
Posted By AZRC4Me

Didn't realize who TV was until I re-read the...

Didn't realize who TV was until I re-read the post. Actually I disagree, pros should be more united to drive the industry to a better place. I know both guys so I'm not stepping in between.
...
04-07-2015, 04:44 PM
Replies: 151
Views: 21,363
Posted By AZRC4Me

And people wonder why pros don't bother coming on...

And people wonder why pros don't bother coming on here. Thanks for writing what I'd be unable to read anywhere else Ryan, and coming from you, we can pretty much take it to the bank.

What I'd...
11-25-2014, 04:21 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

I've been down around 3260 but not any lower than...

I've been down around 3260 but not any lower than that. Ti screws are nice, I run them in all the common areas. Basically, whatever size screws you get in the kit are the places you should use...
11-25-2014, 04:16 PM
Replies: 98
Views: 15,093
Posted By AZRC4Me

So you're using geometry and known equations to...

So you're using geometry and known equations to calculate the wheel rate, suspension rate, then overall corner rate and wheel frequency based on chassis setup parameters. I could see this being...
11-12-2014, 04:04 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

No problem. If you want some stuff to try, go to...

No problem. If you want some stuff to try, go to like 102-103 front droop and 123-125 rear droop. You might have to run the longer of the 2 rear shock shafts, I'm honestly not sure (I know there...
11-12-2014, 01:37 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

I think I've maxed out the front droop at around...

I think I've maxed out the front droop at around 103mm. I always run the TKI shock caps, mainly because they prevent the shock pistons from contacting the bottom of the inside of the shock body and...
11-04-2014, 11:22 AM
Replies: 238
Views: 29,573
Posted By AZRC4Me

Lutz runs for AKA so cross X-Ray off your list...

Lutz runs for AKA so cross X-Ray off your list :lol::lol:
10-31-2014, 04:16 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

Xray seems more logical the way he talks in the...

Xray seems more logical the way he talks in the interview about wanting to be a "pro driver". Oh, check that, Ronnefalk runs AKA so probably not Xray :ha::ha::ha::ha: I'd be surprised if HB can...
10-23-2014, 02:00 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

Tebo uses internal limiters so that measurement...

Tebo uses internal limiters so that measurement can be used to figure out droop. Copy his measurements, going from center of lower mount to bottom of shock body, then install w/o droop screws and...
10-22-2014, 04:27 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

Are you guys really wearing your pins down fast...

Are you guys really wearing your pins down fast enough that you can replace them and keep running the shafts prior to the u-joints getting ultra-sloppy? Because right about the time my drivepins are...
10-20-2014, 10:56 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

It's been a while, but that track had tons of...

It's been a while, but that track had tons of traction so going to 5 actually got the car through the corner quicker because the layout had a lot of on power 180s.
10-10-2014, 03:59 PM
Replies: 228
Views: 20,162
Posted By AZRC4Me

Well, I'm not sure. What I do know is it would...

Well, I'm not sure. What I do know is it would require manufacturers to define what they're doing and stick to it. It would prevent them from showing up to a race with some frankencar and a bunch...
10-10-2014, 03:24 PM
Replies: 228
Views: 20,162
Posted By AZRC4Me

You guys are forgetting that while high-level...

You guys are forgetting that while high-level motorsports don't use "production equipment" (F1, AMA, etc) they still have to homologate their equipment for use and get scrutinized to that...
10-10-2014, 12:14 PM
Replies: 228
Views: 20,162
Posted By AZRC4Me

Everyone seems to forget Ronnefalk was the early...

Everyone seems to forget Ronnefalk was the early pacesetter. Look at laptimes of the semi he ran w/ Ty, it's not like PL had some magical 2 lap advantage, even WITH a special compound that no one...
10-09-2014, 03:22 PM
Replies: 228
Views: 20,162
Posted By AZRC4Me

haha, agreed :D

haha, agreed :D
10-09-2014, 11:33 AM
Replies: 228
Views: 20,162
Posted By AZRC4Me

Your apparent perception that Hudy/X-Ray were...

Your apparent perception that Hudy/X-Ray were some unwitting bystander clueless as to what's going on is more comical.
10-09-2014, 10:35 AM
Replies: 228
Views: 20,162
Posted By AZRC4Me

Why do people make comments as if Hudy/X-Ray had...

Why do people make comments as if Hudy/X-Ray had no clue this was going on? They most-likely instigated the whole thing - X-Ray car not on pace all week, only one car in the final, Ty has been...
10-06-2014, 02:57 PM
Replies: 20,055
Views: 3,443,123
Posted By AZRC4Me

Be sure you're dealing with Kyosho America if...

Be sure you're dealing with Kyosho America if you're in the US:

Kyosho America Contact Info (https://kyoshoamerica.3dcartstores.com/crm.asp?action=contactus)

From that photo it just looks like...
10-03-2014, 04:06 PM
Replies: 49
Views: 4,090
Posted By AZRC4Me

That track would be classified as...

That track would be classified as blue-groove/high bite/new school according to this discussion (at least how I understand it).

This would be an "old school dirt" track (1985 IFMAR Worlds):
...
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.