http://wpsyo.com/doc/pdf/download/ww...w-manual-e.pdf


See Multi Protection System 3

I cant see the 3 flashing lights wtihin this section, I see it talk about sensor wire issues and rotor issues but this is based on other flashing light variations, apologies if im missing something

Sorry my misunderstanding

Only the green led flashes and the other 3 colours should be solid to indicate a fault.

You had something different as if it was in Mode Programming mode

What firmware are you running.

The green flashing LED means there is an error, the combination of the other flashing LED's lets you know what the error is:

Don't think the mode LEDs flash when there is an error listed in the chart.

Nat Manic reported his mode LED where flashing

Correct. All 3 lights flashing which threw me off.

Appreciate everyone's feedback, at least the next person hopefully will see this online and maybe LRP might like to update their troubleshooting guide in the next release 😉

Thank you for your input. I will talk to Germany and see if this will be an issue with future models. ;)

Hi all,
flow comp 200a/phase, flow woks 400a/phase.
What does this mean?
Can flow comp. handle lower than 9.5t motor?
I'm asking this because i saw Team Power Radon Pro V2 esc was rated 140a/phase and they claim it can handle 4.5t motor.
So i think flow comp esc can handle lower turns motor also.
Anyone had try?

Yes I have on my F1 worked great then I put a reventon pro on it with the reedy and noticed power difference

so was it more or less power difference with the reventon pro?

I know this is a stupid question, I have flows in 3 of my cars, with a 1 in back up. I race 2wd, 4wd in off road and touring car aswell.
I am scared of updating because a few years ago I was using the losi speedo, and had problems afterwards. And
So my question is the updates? Does the firewall mess around with the update? And what are the plus points of the updates?

The software allows you to fine tune your speedo for what you are running. For example the offroad software has different throttle and brake profiles than the on road software. I have updated many escs and not seen any issues. As long as you follow the directions and do the factory reset afterwards you will be fine :)

As above, The LRP firmware upgrade method is quite robust however does take about 5min.

The brakes improvements alone is worth the upgrade.

when will there be a new flow lrp

Some of the sponsored guys mentioned end of year after the worlds to me a few months back.