Got hold of Lrp America just now .

They are sending us a new 3.5 program to try ...

Later today will load the new firmware and let you guys know how it went .

3.5 updated from 3.3, new stuff.

Any news if this will be released to the public any time soon? I gather this is a beta build of the new software..

Thanks,
Bill

This is only a beta software. I want to see if this helps fixes the problem on his particular ESC. I cannot say when this will be made public.

John Mora
LRP America CS Rep.

3pk fasst with lrp flow
 

anyone using the lrp flow with an 3pk fasst system in 17.5 TC. the problem I am having is I can not get my brakes to come in smooth. they come in too much or they dont come in at all. I have rebinded over and over again. what setting are you putting the brake and alt at when binding?

http://www.youtube.com/watch?v=Gl1QDeCgsrw

Hopefully this will solve your problem

yes ,

They are sending us the 3.5 to try ..
Will let you know how it goes when we try later this week end .
Still have to get Brown to E mail the File

John

will get him to E mail you later today .

thanks i will try when i get home.

went home for lunch and tried it and can not find that setting in my radio. I have a 3pk.

How do we get this 3.5 software I don't see it on the lrp website?

While attempting to update my Flow Works Team's firmware, the following occurred:

2013-11-16 17:25:57,049 [AWT-EventQueue-0] INFO: File selected
2013-11-16 17:26:01,170 [SwingWorker-pool-1-thread-1] INFO: Starting update
2013-11-16 17:27:01,733 [SwingWorker-pool-1-thread-1] ERROR: Error during update.
cc.lrp.fwupdate1.c.l: Timeout while waiting for echo of block 7
at cc.lrp.fwupdate1.a.f.a(Unknown Source)
at cc.lrp.fwupdate1.a.f.b(Unknown Source)
at cc.lrp.fwupdate1.a.j.e(Unknown Source)

As I now try to complete the update, the firmware update tool gives me "Error Cannot establish connection to speed control!"

I've checked all of the connections and restarted my computer. I also tried another sensor wire. Can anyone offer help on getting this working?

Please offer your advice. I am running 21.5T Boosted. LRP Flow with a X12 21.5T Stock Spec. FDR is 4.0. Speed control running v5.0 with settings 0,3,3,3,6,3,3. End bell timing is horizontal insert. The problem I am having is the car slows down a bit after the first 2-3 laps, motor temp is about 75 degrees c. Any suggestions to what I have wrong?

Please send email to [email protected]. We can then find a solution for you.

John Mora
LRP CS Rep.

This has not been published yet, as it is only Beta right now.

John Mora
LRP America CS Rep.

I've not run boosted 21.5 but I would gear it closer to 5.5fdr and boost up if needed. I'm thinking that you are geared too low putting stress on the ESC causing it to slow very shortly.