UWotM8

Not trying to be rude to the other people who posted, but, DO NOT take your gearing up to 6.5, because the motor will probably blow from over revving or be slow. As far as turning the boost back and starting from zero, its abit of a time wasting exercise since you will end up with allot of boost to be quick anyway. Like i said it's about the rev range, how much boost is applied per certain amount of rpm.
try, 38 boost, 25 angle as well,
Think that will work well also :)
Maybe take the can back a fraction after you test the effects of the boost and boost angle changes
Make sure you install two fans bowing on the motor before you try any of this !!!!!!!!!!

flow up grade bridge and windows 8
 

Tried various things and just cant get this to work with windows 8 is this a problem or me being a dope.
What windows version works best with the bridge.

Works fine on an old Windows XP Proffessional system.

Does not work with Windows 8. Says it on their website. It works with XP and 7.

Technically your correct, however i have been using my lrp link on win 8 for months.

http://www.rctech.net/forum/12206732-post517.html

unsupported but figured it out. 10-4.

Hi guys,
I'm running a lrp flow works team esc with a reedy 4.0t. I need some settings for this for a 1/12 1 cell setup.
Thanks

got my flow back thursday and ran it this weekend and i worked perfect in my mod race.

I forget my exact settings, but you can try starting with someone like 4,2,0,3,3,1,0 and go from there. Up the boost settings and initial drive as per your preference. I have an LRP motor so I use torque timing and have a little more boost than the above settings.

I would also recommend looking at Keven Hebert's thread for his settings, since he is running an LRP Flow with a Reedy mod motor.

flow blinky setting in ver 5
 

Just updated my Flow, have the boosted settings sussed out,but seem to be struggling with blinky settings .
Running 1s lipo could some one post the sequence of setting running 1s blinky with 13.5 in a pan car please

Blue LED Blinking Rapidly
 

Pls help me!!
Why my Blue LED blinking rapidly? All LED not flashing, only Blue.
Anybody hav this problem before?

Blinky mode? Setting up Mode 3?

Not in blinky mode. Battery is fully recharge. I'm using LRP x12, Mode 3 in 5 deg.
my setup is 0213810. LRP x12 13.5T. It seems like shortage of power when it happens.

The shortage of power may well be because it is reverting to blinky mode because it is losing the sensor signal so check your sensor cable and sensor boards.