Looks like this thread was moved out of the on-road forum so I am not sure how many folks will be interested in this, but here is my latest setup sheet from mod 1/12th with the LRP Flow WT:

http://chrishillier.com/wp/wp-conten..._MHIC_2016.pdf

Thank you for the settings.
We run X20 4.0, 32mm rollout and 5.4 firmware with the settings:
8-2-0-1-0-2-2-2 these settings got a lot of boost and is similar what Olly is running.
We usually play with the boost and angle between 1-1 and 3-3.
I hope this helps

Are you sure on those settings? Mode 2 (Brake Type) doesn't have a third setting, and Mode 8 (Protection) doesn't have a second setting.

Otherwise, these settings look similar to what I run. Depending on the rotor you use with your X20, you might want to add torque timing to make the bottom end a bit smoother.

Your right the brake settings are 2 not one, but the protection settings are possible to set to two.
You got a PM.

Does any one know if a new ESC is coming out? Or updated software?

Team drivers have had prototypes for around a year now. So can't be far....?

I have windows 10, I open the program, connect bridge, get solid blue light, hit connect and the program closes. What do I need to do? Plus I cannot re download the program itself.

I'm tempted to put my LRPs on my logic analyzer and compare to see what the marketing terms "stock-x", "semi-x" and "BD3" really mean. I have a sneaking suspicion that it's just different/dynamic brake frequencies. And 4.7 might use a different preset from 5.4.

However with the 5 minute firmware updates.... sigh...

try this

...

...

Hey guys, someone could help me ?

I just got my Flow and plugged Trinity D4 13.5 ss on it.

Can anyone help me with setup ?

i cant beat the LRP motors.

Which gearing ?

Large asphalt track

Boosted setup

I just bought a USED LRP Flow Works team ESC.I am installing it in a 1/10 2wd buggy (indoor off road clay track - medium to high bite track) . I'll be racing stock 17.5T .

As of now, the ESC works with my Reedy M3 17.5T motor.
How do I know if the ESC is in blinky mode?
OR if it's not, how do I put it in blinky mode?

Blue LED will constantly blink...

Kinda depends on which firmware is on there, but setting the modes for "torque timing" (mode 5 on v5.4 Stock) and "boost timing" (mode 6 on v5.4 Stock) to a value of "0" should do it. Check the manual.

thanks... I figured it out.