Thanks again Jesse!

You da man

Is there a more specific date for te VTX yet?

I will be running my Viper equipment in a Losi xxxT-CR.....I will be running Baumgartner's truck this summer indoor at my home track.....we have the clay base in for the most part, few more loads for the base then we are going to till it then roll it/ tamp it.....waiting on next several loads for the layout itself......I will be running 1/10 truck A LOT soon.

Man, I hope it's soon. I pre-ordered mine and I HATE this waiting.

We'll see if we can't get some Viper love spread to SoCal ;)

I promise you will be glad you waited on this.......These ESC are smokin fast with tons of adjustablity.......:nod::nod:

i ran my 8.5 and vtx10 on a high bite red clay/sugar treatment Track it was a tire eater.. Ran Non Sauced Pink Bk Bars Gone in one pack.
Ran them for about 4 more and never a loss of traction.

I left my Onroad Set up on the vtx10. I did add a bit more Brake to it though.

Max adv timing 20*

Acceleration Boost16*
Start rpm 4000
end rpm 20500

Ran 25/78 in a b4 buggy with a 5700mah 50c Speedzone pack.
Car was on rails
My car set up is.
T4 long chassis
270mm wb
Scrubs/ribs (track today i ran ribs because the soft scrubs were wearing to fast)
Bk bar/Insidejob Both sets were bald after 4 mins. But never got loose I could pull the front end up off the ground under real hard acceleration.

Front shocks
no droop limiters.
2 pistons with 35wt oil no rebound
Brown springs

Rear shocks
3 pistons with 2mm droop limiters
35wt oil no rebound
green springs
Proline wing cut all the way down.
Proline bulldog

Car was Hooked up and On rails! i was doing backflips with it.. hopefully ill get a picture of it and post.

here is pic

http://i963.photobucket.com/albums/a...4/d46dc4cb.jpg

First shipment of VTX esc's will be arriving Thursday or Friday!! :nod: We really appreciate your patience, it will be worth it in the end :) Almost done now! We will be receiving new VTX shipments every week for a while now.


That track posted above looks sick!

Excellent!

Pre order while you still can and be the first to get em at Premierehobbies.com!!

Use
"VTX10" for 10 off a VTX10 speedo
"VTX10R" for 15 off the VTX10R
"VTX10X2" for 25 off any two VTX speedos!

Only at
Premierehobbies.com

Got my viper 13.5 installed the day I was leaving for "Battle of the Brands"
Motor ran great as you can see, and with some more time to test things will be perfect.
Love the torque of the motor, allowed me to do some new settings and gearing that I think allowed me to get more control and still have great top speed...
Attachment 740571

Good looking truck!

Does the VTX10 come with the pc interface, or do you have to get it separately? Also can you combine codes at premierhobbies?

No, you cannot combine codes.... you cant do that anywhere that i know of...

And the PC link is just for firmware upgrades.

the programmer that comes with it does not require any PC interface to work.