Hi, yes it seems like you are missing a lot of info, you should get the volts for each cell, fallback for each cell, basically everything. Send me the .ptm file and I'll check it out.

[email protected]

from Phil

Everyone keeps saying that Phil has the new version but is it posted somewhere? Can someone email it to me?

Thanks

try this link. PT software

not sure if it's v1.5.6 but it's just downloaded OK

Its version 1.5.5.

Loan a charger to Rinkrat99 and look what an EE is digging into!!!

Crimson Eagle, He has my new 30 amp unit you got to me this fall. Unit has worked great, and charging has keep me on the battery power with the 3700's. I'm off to run 1/8 gas this summer, so loaned the charger - thanks for all the help.

Come fall, it'll be ready for some new cells, so I hope you get a chance to play with the 4300's

Look who wrote an response back!

Now Grenade when Chris gets me the right software there is no stopping me from gathering data!

Chris if you want to try some HOT motors, try the Integy Matrix 19t (Atlas based) and the KOS27 Stock!

Rinkrat

Thanks I'll give them a go after I get the Nats out of the way.

Anyone coming to the Nats?

Chris

Hey Chris

If you are running the same level of software, that does not explain why I am not getting the full data set.

Any suggestions?

I have a bare bones old laptop I use for my testing which I think is the latest version. I just don;t have the actual install program for the latest version. I had it on a usb flash drive but that died on me a month or two ago.

Chris

1.5.6 is almost the same as 1.5.5. One difference is that 1.5.6 has the function to avoid the error by TIMEZONE. However, this does not affect the user of the United States or Japan.

runtime error may be generated when your PC runs short of DLLs. Please download runtime from microsoft, supposing you encounter runtime error.

http://www.microsoft.com/downloads/d...DisplayLang=en


Thank you,
Kimihiko.

Ok Chris, I have a slight problem here. Saturday at the race track I went to slide my charger over (touched the side of the case) and got zapped by it (no wires were crossed or anything shorted out externally as far as I could see). I looked at the screen on the Protrak and all I seen were vertical lines on the screen (see picture). I then checked my other charger that was hooke up to it to see if that got messed up, but it wasn't. What can I do or check to correct this problem? Any help would be appreciated. I called and left a message on your machine. Thanks!

Hi,

Thanks for the pic, as we discussed on the phone I'm working on it and I'll let you know as soon as i find anything out.

Chris

Excellent Chris! As always it is a pleasure to talk to you.

should of been pm