Is there a replacement antenna for the 92744 rx? Mine broke off and use it only on my carpet cars, but would like to have it as a backup for outside racing.

I'm almost positive it's the "clip on" type.

http://www.hobbypeople.net/index.php...-t01-5503.html

I couldn't quite make out the gold connector end in the pick but the aerial cable should be the same as almost all other brands style of generic clip-on aerial cable. Pretty sure the linked replacement aerial should work fine.

That is it. I have 2 of the actual sanwa pieces and they look exactly the same.

http://shopping.rcmodel.hk/radios-ra...1-p-20167.html

why the rx 451/451R still pricey, even they are 46.. and 47... they should lower the price. any receiver that can be paired with m11x? (above 451r series)

Every Rx airtronics makes can be paired with the m11x.
I use the new ones (92014) with my m11x

Are you sure? I am pretty sure the RX461 is not compatible.

from airtronics
"This receiver is currently compatible with ONLY the MT-4 4-Channel 2.4GHz FHSS-4T transmitter."

Hey everyone... I've been running a 4pks for a few years..but i have an M11x

can anyone explain the receivers compatibility between the M11x and M12!

Thanks a bunch

M12 can use any fhss2/3/4 receiver
M11x can use any fhss2/3 receiver

thanks

Jason, if you look at the following Sanwa website:

http://sanwa-denshi.com/rc/car/receiver/

You can see by clicking on each receiver, that the FHSS4 receivers 471 and 471W also are compatible with the M11X.

The 471 comes standard with the M12 in my part of the world.

You just don't get to run FHSS4 on an M11X, off course, but FHSS3.

Any M11x owners out there have intermittent power switch problems? I recently discovered that my transmitter occasionally won't power on properly when I move the switch to the "on" position. The strange thing about this problem is that the blue LED on the front of the radio is illuminated, but the LED screen doesn't power up, and no signal is sent from the transmitter to the car. Again, this problem happens once every so often, but I fear the TX signal being lost unexpectedly during a race if the unit decides to "power down" on its own.

If anyone's seen this behavior before, and went through whatever steps were necessary to resolve the issue, I'm listening...;)

It started happening to me just a few days ago. I just make sure the switch is all the way up and it helps but I'm not seeing the steering and throttle inputs on the indicator menu that you can always see.

When I use the steering or throttle, the inputs are seen in the expo menus or Dual rate menus but you can't see them in the menu that shows your trims and switch positions. It doesn't affect functionality directly and I haven't really bothered about it.

Hi All,

Is there a FACTORY RESET option for the M11x?

If not in the menu, is it possible to remove a battery or short it to reset?

Thanks.

Go to a model memory you have never used. Make it master, then copy it to your used model memories.