You're welcome. :)

My measurements were with a basic ruler so they might be a little off. Give or take 2-4mm.

so if i buy this radio, and all my cars have a spektrum rx, you mean i would have to replace each rx because i can no longer use my module setup???

wow, what a way to corner the market.

You're a little late to the party. New radios don't use modules.

late i know, ive been away from this hobby since 09

Hey guys,my wheel is not returning to center it seems. Have any of you had to replace the return spring??How hard is this to do ? Thanx ...It just had to be snugged up not replaced Cheers!!

Anyone know where to get a good deal on a hard case radio box for the M11x ?

I got the protek case. So far so good!! :nod:

damn i really love this muscle radio

How do you guys adjust your finger to the large trigger? I tried using the first phalange of my finger but it keeps slipping.

I know of the fuel tubing or heatshrink method but the fuel tube I have is too small in diameter and I'm not sure about using heat near the radio. I use a hair drier and not a heat gun.

Are there any other ways?

Maybe take some electrical tape and wrap each side of the trigger a few rounds. Wrap it tight so it looks clean when done. Just be sure to hold back on the trigger with even pressure as you wrap, so you don't bend, or snap it off.

JB WELD.. Or silaprene.. the silaprene sets up in 30 minutes..

use a little heat and tweak the brake side of the trigger to fit, if you are careful a simple lighter does the job in minutes. This is one of the not often talked about things that can make a huge difference in your control.

I would prefer not to alter the physical state of the trigger in any way. I'll just try a tube with a larger diameter and see if it fits.

I agree. Try some electrical tape. No offense to the other 2 but I wouldn't do either of their suggestions. :weird:

i like to use old o-rings. just slip few of it, so its covering all of ur trigger surface.