|
They advertise right on the case that the receiver is Ant free, but mine came with a huge cockroach!
|
Originally Posted by glennhl
(Post 16026600)
They advertise right on the case that the receiver is Ant free, but mine came with a huge cockroach!
|
Originally Posted by sawzall
(Post 16026570)
Had a chance to try out a DasMikro FHSS-5 receiver. Used it in FH5 mode will SSL with a PGS-CX2 servo and CODE10 worked as expected. I also tried it with SXR in FH5U mode and it also worked fine (I honestly can't tell the difference between SUR and SXR). I didn't experience any signal loss, clipping or other oddities. I also compared its range to a real Sanwa 492i, and it was pretty much the same. I haven't tried FH5U with the PGS-CX2 in the SSL port, but I'll try it over the weekend.
I'll still run original Sanwa receivers in my competition cars, but this looks like a nice alternative for bashers and some of my 'fun' chassis. too bad that mine not working,......... |
Originally Posted by choisan
(Post 16026664)
oh, that is good to know yours working in ssl, did you set the servo with different racing steering modes (parameter)? can you share what you set code10?
too bad that mine not working,......... |
There's a new Sanwa compatible receiver coming out! Looks like it might be a rebranded Das Mikro - https://www.redrc.net/2023/08/takash...s/#more-214127.
|
There is review on Sanwa original RC-492i compared to DasMikro FH5 RX on youtube.
https://youtu.be/LRrRNc7iaj0 |
Originally Posted by sangyue
(Post 16028810)
There is review on Sanwa original RC-492i compared to DasMikro FH5 RX on youtube.
https://youtu.be/LRrRNc7iaj0 please kindly advise if i missed any. thanks |
I noticed there is a V2 of the FH5 receiver from Das Mikro. I perused the last bit of this thread and didn't see if the discussion is V1, V2 or both? Curious if V2 corrected the issues that were present in early versions. I need to order some of their FH4 receivers so if things are looking up, I'll add an FH5 to the order.
|
My one that has brownout issues is the original version.
|
oh, how to tell which is v1 or v2? i guess my unit is v1.
|
Originally Posted by choisan
(Post 16029851)
oh, how to tell which is v1 or v2? i guess my unit is v1.
V1 https://cimg9.ibsrv.net/gimg/www.rct...f36b54e873.jpg V2 https://cimg0.ibsrv.net/gimg/www.rct...c303361f0f.jpg |
And that also means it is technically different?
|
Originally Posted by Roelof
(Post 16029903)
And that also means it is technically different?
|
Negative
All relievers have neg on outside besides v1. V2 has neg on outside. I have 6 fake receivers. They all work fine.
|
Originally Posted by Roelof
(Post 16029903)
And that also means it is technically different?
normally it is considered major change in term of technical after such a short product launch |
| All times are GMT -7. It is currently 11:18 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.