tc4basher

I dont know of any ESC that can power that beast. Good luck finding one

fdjizm

I buy crazy things, I'm not proud of it.

MallenP30

I've tested this motor on the Mgt7 with 6s, the XLX can't handle it and shuts down, you'll need to use well under a 1:1 ratio or have an extremely light car for it to work out!

fdjizm

Oh yea? does it spin too fast for the ESC or just tries to pull massive amps?
I feel like I was making progress just fine with my 2200kv motor, then I had to start browsing the internet LOL.

MallenP30

Yes my guess is it tries to pull too many amps

MallenP30

I did run it successfully a few times with small gearing but only hit high 130's and the esc was super hot, therefore not getting the full potential at all

long island rc

you think you can get the full potential out of it if you use one of thoes crazy mgm 1000$ esc

long island rc

What would be better kv for a tp 3650 in a 2wd salsh on 6s.right now I am thinking the 2350kv or the 2060kv. Have the castle 2400kv right now around 110mph. These motors are 10mm longer than the castle and higher quality. So I am thinking I could get 120-125 and my goal is to break 130 evenuly.would I need a 4050 or4060 to do that or can I pull it off with the 3650

MallenP30

I'd go with the 4060 or the 4070, on 6s anywhere from 2200kv-2900kv, just depends on what you are looking for and how you gear it

long island rc

4070 I think is a little over kill and I know jm speck has done 120 with a 3650 sized posidon motor and he said it can do more I might go 4060 but I feel 4070 is complete over kill for a 2wd. I would like to try and do it with the 36XX sized motor but I will move up to a 4050 or 4060 if you guys don't think it can be done.

tc4basher

130s in a 2wd Slash will be tough no matter what motor you run. I would go with a 40xx series for a pretty big slash.

long island rc

I am doing it because it is hard and beacues I want to have the fastest slash/rustler/stamped 2wd. And thanks I think I am going to go with the 4060 1950 or 2450.

tc4basher

Sounds like a good plan. Nothing wrong with a good challenge. Good luck with that.

fdjizm

I'll give it a shot and put a current limit on the XLX.
I've been pulling about 220-230amps with the 5682 for 105mph.

phildoggg

iTrader: (24)

There is a guy on yt running the 3200 in a rustler on 4s and i think he hit some good numbers..