1/10th pan car
#17
Tech Apprentice
I've got a RC10LS. Can I fit a RC10L3 Oval & RC10L2's chassis without any modification onto my 10LS?
#18
Tech Champion
iTrader: (21)
Ivan - Go to: http://www.rc10.com/racerhub/techhelp/tech10l.htm . Your exact answer's probably somewhere on that page. I think you'd have to at least buy or drill the lower cross-brace on the rear to use the L2 roadcourse chassis and making it into an oval car would involve a whole new rear (narrow) pod.
#19
Ivan: According to AE, no it won't. The whole rear pod and chassis brace assembly is different. You basically have to change everything but the front suspension and the motor plate.
For the cost, you could just buy an RC10L2 and convert it to an L3.
For the cost, you could just buy an RC10L2 and convert it to an L3.
#24
Originally posted by ovalnator:
The reason it wont work is because the rear pod of the 10LS is wider than an oval car. The axle and diff hub are much longer when compared side by side w/ that of an oval car
The reason it wont work is because the rear pod of the 10LS is wider than an oval car. The axle and diff hub are much longer when compared side by side w/ that of an oval car
Last edited by TurnNBurn; 09-21-2001 at 12:47 PM.
#25
Originally posted by MarkA
Taz – Did anyone from NorCal enter that you know of? They only had 8 entries for the class as of a little while ago, and counting myself, I know that seven of those are us SoCal guys.
Taz – Did anyone from NorCal enter that you know of? They only had 8 entries for the class as of a little while ago, and counting myself, I know that seven of those are us SoCal guys.
#26
Originally posted by TurnNBurn
Actually, AE has a list of parts needed to convert an RC10L2 to use the 3-shock setup. I guess it uses some parts from the RC10L3 Touring. I'm thinking that the 10L3-T uses the same width rear pod as a 10L2, but a different axle to keep the width down to 190mm. If that's the case, then you could use the standard 10L axle to get the standard width.
Actually, AE has a list of parts needed to convert an RC10L2 to use the 3-shock setup. I guess it uses some parts from the RC10L3 Touring. I'm thinking that the 10L3-T uses the same width rear pod as a 10L2, but a different axle to keep the width down to 190mm. If that's the case, then you could use the standard 10L axle to get the standard width.
I do not know if you can make a 10LS or a 10LSS in to a 10L2 or 10L2O.
#27
Originally posted by Taz_S:
I do not know if you can make a 10LS or a 10LSS in to a 10L2 or 10L2O.
I do not know if you can make a 10LS or a 10LSS in to a 10L2 or 10L2O.