where i can get N12 LS???? i cant find it in online stores!!

What header and pipe do you guys recommend for Novarossi .12 LL3 engine to run on a big track.
I use Skyline VR+ and picco but not very impressed.
What do you think about 2630?

You can try the the Max 2602 pipe set, the JP 2620 pipe set and Nova 2630, all this mentioned pipes will give great power.

try using a short conical header (4 or 5 fins) with the skyline...
;)

Thanks Sam and Keavze I will try the pipes that you mention

Hello,

I was wondering if anyone heard if Novarossi is going to release a new .12 engine for the 2009 season? I am currently looking to pick up a 353, but would like to know of something new is around the corner before I do.

Thank you!

If there is a new model I would not expect something compleetly different. The differences between the plus 12and the 353 aren't that much and I know a lot of drivers loving the "older" plus 12 more.

The latest devellopment from Novarossi are the tuned and pre-runned engines.

yes i too want to buy a new novarossi 353 but there might be a new model comming soon, time will tell. we will all see what will happen at the toyfair in february, there almost all manufacturers present there new product, just be patient....:sneaky:

word of advise if your going to spend the on the 353 tuned get the murnan modified 353. Dont let people tell you other wise because the murnan is a lot faster than the tuned version the tuned ownly has a little bit of crank work were the murnan modified 353 is full modified.

just checking... are the sts .12 con-rod same with the novarossi 7601 con-rod?

when i say 353 i MEAN the murnan modified of course:p:tire::nod:

Hey guys just wondering what sort of pipe would be best for the
Novarossi 3SCT Tuned, i got the Skyline VR12+ and the Mugen Pipe (2501) it is for a short technical track with a 30m back straight.

thanks

Mitchell

i have the sct and use the novarossi 2630 and makes great power, but might affect your run time...

NovaRossi 367
 

Just got the 367 from rc-toro.com. I am currently using it with 9886, but there seems to be not much torque at the low end compared to my OS Vspec. What pipe should I get to bring the torque out? thanks in advance