6/05/11 Race Results
 

Round #1 and Round #2 of CRC's Sunday Series was run on 6/5. Round #1 was to complete a rained out event. Traction is always good at CRC and lap times are fast. Tires of choice are the VP Pro Turbo Trax in Ultra Flexx compound which were dialed. Always using VP Pro wheels. Using my standard CRC set up the car felt dialed. Jumping right to the main for round #1 I was sitting 4th. The car felt great throughout the main and finished 3rd.
Round #2 came around later in the day. Running the same set-up and tires I finished 3rd and 4th in the qualifiers. That put me 3rd overall. Again the car felt great and was running consistent. No issues throughout the race. I finished 4th. The GO GX-5R Engine had tons of power and top end on the straight. Fuel mileage was easily 8 minutes with more to come. Running temps were low all weekend using S&W Fuel Trophy Blend 30%. Tire wear was almost non existent.
It was a great day for Caster Racing USA, GO Engines USA, S&W Fuels, and VP Pro tires.

Jarodd

Just finished my 2nd gallon on the GXII. Very nice power band and easy to tune. Looking forward to more racing with this motor. Thanks Trey!

Lol...thanks mike...I tried...but my tires were not good for the cold weather...srill had a blast...and the gxii was on point all weekend :D

good meeting you, bro... and glad you and Aaron were out there to represent! Too bad he didnt take me up on my offer to let him use my mugen. Poor dude had electrical probs all week.

glad to hear it viking!

Thanks...likewise. ....yeah sucks sooo much, he never even got to warm up the motor on any of his runs before a car or electrical failure would happen....then by the time we fixed all the issues and he had one more chance...the car flamed twice, finally got it tuned and another rear diff blew up:flaming:
Oh well....still had a blast all week.....remember.....jacob haas:lol:

Still a no show.:confused:

ok I'll get one out for you tomorrow :)

Your the man trey!:nod:
hey can you post or send me those pics you took of my truck at the nats?...thanks bud:D

I have to look at what I took. My batts were dying when you were up. I think some of them came out, but like I said... I gotta check.

For sure....I meant the pics you took of our pit area....but no biggie....thanks bud

oh yeah... duh :)

:batman:

Anyone have the manual to the Go 25? :)

Go here and download the PDF file

http://www.go-engine.com/download.asp#

You are after R256P - P420SG