I would say it lost lubrication on the wrist pin...the Disco doesn't have upper rod bushing, its steel on aluminum ....Sorry to see your engine fail .....just to be clear to everyone, this is not one of my modified engines, I do not do mods to the Disco's !

No this is a stock one. But both bushings show no wear. The piston end is still intact. It broke right below it.

The nvision rod is a little cheaper than the Orion. Will it fit ok?

it split at the bushing...based on what I see its lubrication issue.....the bushing grabbed the wristpin and broke the rod....I am not sure of the other rods will work...They not engines that I usually work on so I have no data to offer you....sorry !

Best comment today running my bonito what the hell are you running:lol: I was passing e buggies on the straight early by more then a few car lengths :D

LOL, yeah your moto had some boto bro! looked good out there.

I still have not ruled out getting another motor. I got it in August and it did not last anytime and I run on the rich side. I only club race on a small track. I paid 157 shipped from Stormer and a new rod cost 60-70 bucks. So would you rebuild it or get a new one? Thinking about a Fusion X3 or Werks B2.

Why not a P5 or B5 ?

Best comment I heard on the week end was what type of jet engine you got in that thing today, Novarossi P5XLT & 2058 pipe was the answer.

Nice to see others taking note

I want keep it under 200. That motor look almost new inside, and seems to have plenty of pinch/compression left. So I may just buy a new rod. Know anyone who knows about LM made engine who can compare the Nvision rod to Team Orion rod? $62 vs $50

ran my first cre engine over the weekend. nova 21-4btta in truggy. pre run in. out of the box. easily making 10 min runs with a nice usable power band. helping me capture 1st place at the meakin masters. cheeers guys

Congratulations my friend !!!!!! what pipe were you running ?

ran aplus 0801 pipe with aplus a7 manifold

Anyone tried using the 2058 with the header from a dynamite 053 pipe?