RcRenew.com engine resizing and epoxy crank re-filling
#512
Yep! its always nice getting e new engine Have got xlnt feedback so far on the Argus engines. They break in pretty easy as well. I Have been adding the included extra "break in shim" for break in. Then just remove it after 10 or so tanks. Just heat them up before each start until they loosen up a bit.
Thanks,
Lance
RcRenew
Thanks,
Lance
RcRenew
#514
thanks,
Lance
RcRenew.com
#516
Thanks for the update! And yes the do have a lot of power. On your next one let me know what you want to do. But stock they do very well already.
Thanks,
Lance
Rcrenew.com
Thanks,
Lance
Rcrenew.com
#518
Thanks,
Lance
RcRenew.com
#519
#520
Jess, received your engines. We Will contact you shortly after we inspect them.
Tom your P/S sets arrived and are being serviced.
Thanks so much,
Lance
Rcrenew
Tom your P/S sets arrived and are being serviced.
Thanks so much,
Lance
Rcrenew
#521
Jess, your engines just needed a resize, The Bearings,Crank pins and rods look great Shipped out today, tracking was e-mailed to you.
Tom, you P/S sets were resized and shipped out.
Thanks so much guys!
Lance
RcRenew.com
Tom, you P/S sets were resized and shipped out.
Thanks so much guys!
Lance
RcRenew.com
Last edited by Rcrenew; 02-14-2011 at 08:07 PM. Reason: spelling Darn it!!lol
#522
Had a couple questions on the restrictor size on the Argus A52 engine. Stock comes with an 8mm carb restrictor but we do have the 7mm available on our website.
Thanks,
Lance
RcRenew
Thanks,
Lance
RcRenew
#523
Chris, Lem and Fred your Orders arrived Working on them as we speak
Thanks,
Lance
RcRenew
Thanks,
Lance
RcRenew
#524
All orders received today have been serviced and shipped. Tracking has been E-Mailed to you guys.
Thanks again,
Lance
RcRenew
Thanks again,
Lance
RcRenew