Joe, do you still sell the filter oil because I could not find it on your site.
Thanks,
Tony

yes i still sell filter oil. Its not on the site now cause we just ran out of bottles. Most ppl order their filters pre-oiled so it hasn't been a top priority for me at the moment. (just moved across the country last month.) shoot me a email at [email protected] and i'll get you taken care of. Thanks!

Yes Been racing at PIR. Also went to the Xmas classic Bumps and Jumps. Man I miss nitro!

Where is PIR?
Do they run Nitro?

I'll hit Bumps and Jumps up before Motorama.

Happy New Year Ed. We are looking forward to seeing you at Motorama this year.

Could someone refresh my memory on the stock needle seetings for the .21 fully modded JS? Thanks in advance.

High Speed Needle: Flush with housing then 0.5 turn in

Low Speed Needle: Flush with throttle-arm housing then 1 turn in

Idle Screw: Carburetor Slide flush with the inside of the Carburetor, then turn idle screw in 1.25 turns (Air Gap will be between 0.7mm-0.9mm at this point)

Happy New Year John,, looking forward to Motorama and seeing you and your family.

I'm excited to see what the track layout will be this year

The only thing I'm VERY disappointed about this year with Motorama is the fee to be a vendor was increased 400%,, this puts a lot strain on the smaller companies wanting to set-up a booth.

As always thanks for the help Ed.

No problem happy to help

Only 2 days left on the 1 year Anniversary sale....

All stock .21 and .23 JS Racing engines: $175 shipped

Its in Darby Pa. Right outside Philly. Approximately 25 miles from the blue rt. Macdade blvd. ext. Check out the PIR thread on the racing form. No nitro only electric.

Um,, maybe I should dust off the old T4 and pick up some new batteries

http://ebmods.com/23%20Stock%20vs%20Mod.JPG

Stock .23 vs Fully Modified .23 engine, I like to call it the FTB (Full Tilt Boogie)

FM .23 includes:
Tungsten weighted crank, lightened piston and connecting rod, rotor timing adjustment, sleeve timing adjustment, and precision matched piston and sleeve.

The JS Pipe used for testing will soon be available