R/C Tech Forums - View Profile: Sprinkler

Go Back  R/C Tech Forums > Members List
Reload this Page >

Sprinkler's Profile

Sprinkler Sprinkler is offline

Tech Addict

About Me

  • About Sprinkler
    Location
    North Carolina
    Interests
    Fishing, RC stuff
    Occupation
    Telecommunications Supervisor
  • Signature
    John McGinty

    Mugen Seiki Racing/ JConcepts/ Tekin/ Absolute Hobbyz/ Advantage Racing Products/ Byron Fuels/ Competetion Heat/ NovaRossi/ Airtronics/ Stickit1racing.com/ Murnan Modified Motors/ M2C Racing

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: 12-12-2014 04:19 PM
  • Join Date: 10-16-2003
  • Referrals: 1

Friends

Showing Friends 1 to 2 of 2

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. 02-08-2010 08:27 AM - permalink
    John, maybe you can help me. I just switched over to the EB Mods motor and am having a little issue with the tune on the motor. I understand that needle settings will vary because of weather but was hoping you could give me an idea where your needles are set. Is it possible to get MM settings in from flush on the high and low needles? I had someone on hear tell me .5mm in on the low and 1.5 in on the high. I am ok with .5 but 1.5 is bottomed out on the high end. I have been running Novarossi based engines all last year and have not had any problems with tuning of these motors. I have got the high end set good for top end speed long straight but the bottom end just does not seem to be responding. Any help would be great.

    Thanks

    Bill Siler
    661 435 3634
    [email protected]

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.