|
Thanks Monty. went to clean up my 9901 and noticed a couple of small dents in the bottom and might switch to my 2058 for this weekend if I can't get them pop out. The dents arn't bad and I am giving it the Anti-freeze bath right now to clean up the inside. try it out and see if it works.
|
Hi, can HES do break in's on O.S. .19 engines?
Thanks! Dave |
cant wait for my HES jp fx 21 should be off the hook i know dont blow it up first lap lol thanks you rock
mikel |
Originally Posted by MIKESRCSTORE
(Post 10832247)
DECODER :man i cant wait for my HES jp fx 21 B5 (rebuild) it should be off the hook! i dont know i might blow it up on the first lap :lol: i have done it before :cry: thanks Houston you rock !!
mikel |
Just got my nova back Monty, thanks again!
|
New Glow Plug .... check
New Gas tank .... Check Freshly cleaned anti freeze bathed 9901 and header ....check all this equals a perfectly tuned, super smooth, perfect idle at every stop, HES btt. Just ran 2 tanks back to back through the buggy out on the street and it was perfect down to the bottom of 2 tanks. 11:30 minutes on the street per tank with the 7.5 mm Monty, this motor seems to want to be at 4.75 turns from bottom on the LSN. Seems that any leaner it will falter and sputter and stall. Started at 4.5 and had to go fatter to get it to run. I'm happy with the 4.75 since its uber consistent. Its going to be a good weekend at the track (knock on wood) :D:D:D:D:D |
Originally Posted by beidle99
(Post 10833191)
New Glow Plug .... check
New Gas tank .... Check Freshly cleaned anti freeze bathed 9901 and header ....check all this equals a perfectly tuned, super smooth, perfect idle at every stop, HES btt. Just ran 2 tanks back to back through the buggy out on the street and it was perfect down to the bottom of 2 tanks. 11:30 minutes on the street per tank with the 7.5 mm Monty, this motor seems to want to be at 4.75 turns from bottom on the LSN. Seems that any leaner it will falter and sputter and stall. Started at 4.5 and had to go fatter to get it to run. I'm happy with the 4.75 since its uber consistent. Its going to be a good weekend at the track (knock on wood) :D:D:D:D:D |
Originally Posted by KSimmonds
(Post 10833004)
Just got my nova back Monty, thanks again!
|
:cry: :lol:
|
Originally Posted by houston
(Post 10848902)
:cry: :lol:
|
He wanted to sponsor me and I said no. LOL! :D
|
Originally Posted by Chris Reilly
(Post 10848993)
He wanted to sponsor me and I said no. LOL! :D
I felt so alone on the second page ;) :lol: |
LoL. Tell me guys, does the X7 match well with a buggy. Used to use a Plus4 and it was great. Right now using the BTT....it's good and all but not quite what I'm after. I use the Xtreme Tuned X7 in truggy and find it to be spectacular for me.
Would like to hear experiences...and Monty's opinion. Hi Monty. |
Originally Posted by air8
(Post 10849167)
LoL. Tell me guys, does the X7 match well with a buggy. Used to use a Plus4 and it was great. Right now using the BTT....it's good and all but not quite what I'm after. I use the Xtreme Tuned X7 in truggy and find it to be spectacular for me.
Would like to hear experiences...and Monty's opinion. Hi Monty. |
Would you reccomend the plus4 team c motor or the 4btt in an xb9? I would prefer more bottom end than my os v spec with the same top end or more would be ok. More than anything I want a super crisp and smooth motor. Also what pipe would you reccomend for the nova motors?
|
| All times are GMT -7. It is currently 09:01 PM. |
Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.