Im sorry man lol. Biggest reason I deal with them is there one state away from me and fedex ground is like 5 bucks and I usually have my order the next day. No your prices are fine lol. But Im sure I will be buying some stuff from you dont worry :)

Not at this order...at my next order from you..
Just to receive my first order soon and then i will make a second...
I told you i am an unlucky guy ,2011 my unlucky season... Two wrong printed labes at my order at some month .... :nod:

you are cursed!!!:eek: stay away!!! stay away!!! :lol:

i am sure it will be fine

Now I am praying ....:lol:
AH i add you in facebook also :nod:

Monty,

Made it right? Nice. LOL. Didn't know it was that wrong. OK, Ok, too much Lucky 7 I know. You going to have any carb o-rings with you in Az.? Might have a carb that may neet some help there. Yes, money makes everything better. LOL. Not to worry though, when I get it, you'll see some of it, I asure you.

Its all good james

Go to bed!

you just wait till RAMA... i got my eyes on you...:D ..

I'm very stealthy! Youth and skill are no match for old age and treachery.

Are you sure? ;)


Engines, parts,pipes/headers, werks clutches,lipo packs for comp heat 12v and lipo for starter box, tuning screwdrivers, exhaust spring hook tool, comp heat 120v and 12v, glow plugs,rbmods after run oil and probably a few more things I am forgetting are all items that I carry so if you need any of these just let me know:nod:

losi collet on Nova Toro Nero
 

HI guys. I've been having a frustrating time trying to get the stock 8T 2.0 collet onto my TN engine. I broke a collet this moring trying to pry open and slide along the shaft. It appears that the tapered shaft of the engine is too thick and wont allow me to slide the collet sufficiently down the shaft. When I spread the collet out it seems to break... I almost broke my 2nd collet. IS the losi collet needed anyway?

Is the point of the collet to get over the entire shaft and rest on the large engine bearing? Is there an alternative collet out there that I can use with the Nova engine and losi aluminum clutch??

ANy pics for guidance out there - Please help!!

Thanks!

every single engine (big block .21-.28) has the same size o.d. on the shaft where the collet sits (7mm) . you are definitely doing something wrong , either post pics or find a knowledgeable local to help ya out .


this is kinda strange because from what i remember of the losi collet it was very loose and just slid right on the shaft :confused:

Ok thanks I'll double check. Is the collet supposed to go all the way down the shaft and on the engine bearing then or is it supposed to stay where the taper begins son the shaft?

are you pushing it on by hand ? or in the flywheel. just push it on all the way untill it touches the bearing,with the taper facing out by hand, it will fit.

thannk you Jerry ;)