im thinking this is it ...as the motor is sirio based

rear
http://tkocompetitiondev.com/product...roducts_id=348
front
http://tkocompetitiondev.com/product...roducts_id=156

i always just put a small zip tie there on all my engines and I also seal the carbs and back plates of all my engines.

i use just a smear of bel-ray all weather grease ... on the inside of the boot ....

[QUOTE][i use just a smear of bel-ray all weather grease ... on the inside of the boot .... /QUOTE]

I'm not saying these are bad ideas but I've never had to do either to keep the carb boot from leaking or sucking air on any other motor. It would be helpful to know if anyone else's ExTech has this flat spot on the carb housing? None of my other motors has it, I think it's an imperfection in my carb.

[QUOTE=KyJoe340;5280454]
no prob either way ...i mean i see what your pointing at ....but it may be time to seal the carb boot ..i mean ive done it on ever motor ive had but the first 2 i ever had ...and never had a problem with a carb boot .....i will check mine though when i get it back from powerhouse .....

Just ordered my .21 mod. Can't wait to see what it's made of:nod:

motor shipping back today from powerhouse rc performance ...man i cant wait to get this thing back seems like i had it for a few days and off it went ....i miss it ....:blush::lol:

EX TECH 24
 

Anyone know where I might be able to pick one of these .24's up? I bought one a few weeks back and wanted to pick another up from Amain but they are sold out.

They had them for 249..w/ the 10% coupon they were 225.00 for the pre - run.

They are 100.00 to 150 bucks more everywhere else.

LMK

I backorderd one from amain. They never showed they got any in but I was able to get one about two weeks later. You may want to backorder as seems like they are sold before they get them.

.

Did you like the way mine ran that much?

Thanks for the pit help in indy Jamie.

Chad

No prob Chad. Ya, it was really fast and smooth. I had been looking at em'. I wanted to see one run. I was convinced. lol

chambers - i have sent a couple orders of engines to Amain early this week.. they should have them back instock early next week...

2056 efra legal?
 

Chad, I am happy owner of 24 EB full moded engine, yesterday i oredred another 24 full moded engine.
I have two questions:

1. Is 2056 pipe EFRA legal, I am racing in Europe so must have EFRA legal pipe on my truggy.

2.I know the first ful moded engines were moded by EB MODS, the second full moded engines were moded by factory.
My question is, can I use the same full moded engine parts in both engines , in EB Full moded engine& FACTORY Full moded engine?

Thanks

1) yes it has EFRA Legal..

2) parts interchangable