the problem is you need the TRAXASS style crank!..and Go ONLY makes the SG style crank....so none of the go's will not work;)....i was trying to get 1 setup for a buddy but i could not get a TRAXASS style crank to run in a GO:flaming:....:flaming:

What if I use this:

http://www3.towerhobbies.com/cgi-bin/WTI0001P?&I=LXJF69

You can see what this guy does here:

http://www.misbehavin-rc.com/pit-lan...motor-swap.asp

I have a new rotostart backplate for a .25 Go, you need the .25 sport motor with the drive pin in the crank. Go Usa had some a few months ago.

Rex

Not sure if the one I have looks just like this but this is it.

http://www.go-engine.com/go_engine-2.htm

Rex

those wont work either!...the problem is the crank...it needs to have a slot for a C clip at the clutch end...and the only adapter is for a fully threaded crank...which Go does not make....i already tried this:flaming:...i wanted to get 1 running for my buddy to go bash around with:nod:

Why can't I just cut from the threaded part here and add the clutch adapter mentioned above?

guys,

I just got my hands on a R21 3-port w/ novarossi carb.

I own (3) d8t truggys.
should i bother, what will this motor be good for????

Three port would work on a buggy, but truggy not so good. Just for messing around it would work. Five port is preferred for a truggy.

3 port works great in a truggy. It has as much if not more bottom end than a 5 port. 7 port works great in a buggy. The 5 port is recommended in a truggy, but the 3 port works great as well.

I'm running a 3 port in my truggy and a 7 port in my buggy. I have one older 5 port and a new gxr 5 port i'm piecing together right now for backup engines.

anyone run at rev in socal??

I LOVE MY GX5R!!!!!!!!!!!!!!!!!!:nod::nod::nod:

I'm in need of a gx-5r tin coated crankshaft. If anyone knows where i can get one let me know. I've been bidding on ebay but have yet to win one. I'd like to pay about $30 if possible.

doubt it!...thats less than the DEALER cost!...

I have a new one for a Mg66, it is the same except for less weight on the counterbalance. Not really where I would remove weight on a motor but it should work ok. $45.00 shipped.

Rex

how come i get YELLED @ when i try and PUSH my engines!.....you arent even a GO dealer anymore!.....you straight up PM'D me and told me i am TOO PUSHY....:lol::lol::lol::lol: i see you EVERYTIME someone wants to buy something