Originally Posted by cheesecake (Post 4618239)

you must race with some verry slow people then :lol:

Originally Posted by skeller (Post 4618232)

Here's a little video my wife took from round 4 of our points series here in Bama. I'm running my PTM Go 3R with approx. 4 gallons on it.....and I'm the slow red car.


But I did finish 2nd.................




http://www.youtube.com/watch?v=c97czXcEv1s

Originally Posted by grizz1 (Post 4617880)

Make sure you have a real strong starter box and heat that baby up with a hot air gun or powerful hair dryer otherwise you will struggle to turn it over. The 5 and 7 port Go Techs have mega pinch when new. Check out the break in procedure on the bottom of page 78 on this forum. Follow this and you will be sweet. Those needle settings are spot on for break in. After 15 tanks or so you can start leaning the LSN toward 2.5 turns in from flush for normal running.

Originally Posted by skeller (Post 4618261)

The winner's avg. mph was 6.75.................mine was 6.40.

Originally Posted by Dasupacat1 (Post 4619869)

Will these settings work for a 08' 3 port race......I have yet to break mine in.

Originally Posted by grizz1 (Post 4620019)

Nice driving / nice camera work - what a team ;) :cool:

Originally Posted by skeller (Post 4620135)

Thanks dude....I'm lucky that my wife kinda enjoys this stuff a little.:)

Originally Posted by will g (Post 4620313)

here is my x2 truggy with GO .25 6 port engine and hong nor 2027 pipe

Originally Posted by herb99 (Post 4620469)

How does this engine pipe combo go?
I have a 2027, I'm thinking about putting a .25 GO in my truggy.
Are you happy with it? What sort of run times are you getting?
Thanks

Originally Posted by chucked (Post 4622852)

There is currently an ebay auction for a set of 4 got tech inserts for $14 (47 available) buy it now. Not sure if its ok to post a link, but the auction isnt hard to find. Has anyone tried these inserts or ordered from this seller?

Originally Posted by beeanner (Post 4610598)

Hey guys, I have a question and sorry if its been asked before. Im also new to nitro stuff so bare with me :)

I recently installed a 3PT motor in my buggy, broke it in as followed. Installed a JP-2 pipe on it, byrons 30% gen 2, p3 plug. Motor runs around 210-230 with motor settings at a little lean on the bottom and a touch fat on the top. I also have the carb restrictor in that came with motor.

The problem im having is the motor seems to have no bottom end at all. I went from a 1.0 clutch spring to a 1.1 spring with no difference. I just cant seem to get any rip at all out of the bottom end. Mid range and top end are ok, just killing over bad on the bottom.

Do I have the wrong pipe on? Wrong plug? Ect? Any tips and info i can would be helpful!

Originally Posted by vnmsgt (Post 4622915)

I have them in stock too. I use a 7.5 on my 7-port and it is fine. They are very high quality and aluminum and not plastic like alot of others.