problem with tuning
#1
Thread Starter
Tech Apprentice
Joined: Jan 2011
Posts: 96
Hi All,
Any idea why my car is running sooo inconsistent? , idle gap .5mm bottom needle as lean as i can go without raising the idle so its too fast.. top end runs as high as it can without over hanging the revs coming back down. Just wont hold a consistent idle.
Any idea why my car is running sooo inconsistent? , idle gap .5mm bottom needle as lean as i can go without raising the idle so its too fast.. top end runs as high as it can without over hanging the revs coming back down. Just wont hold a consistent idle.
#2
Hi All,
Any idea why my car is running sooo inconsistent? , idle gap .5mm bottom needle as lean as i can go without raising the idle so its too fast.. top end runs as high as it can without over hanging the revs coming back down. Just wont hold a consistent idle. https://youtube.com/shorts/lbzisG6j21k?feature=share
Any idea why my car is running sooo inconsistent? , idle gap .5mm bottom needle as lean as i can go without raising the idle so its too fast.. top end runs as high as it can without over hanging the revs coming back down. Just wont hold a consistent idle. https://youtube.com/shorts/lbzisG6j21k?feature=share
#3
Thread Starter
Tech Apprentice
Joined: Jan 2011
Posts: 96
#4
#7
Find the right tuning for the LSN and HSN and correct the idle when needed, the idle is basically the last one to set.
That JQ instruction is based on a certain OS carb but you have a REDS engine that is different. Beside that, the JQ instruction of a 0.5mm gap and tune the LSN from there does sometimes also not work on the OS carb, tolerances, different fuels and weather conditions has a lot of influence on the final tuning.
That JQ instruction is based on a certain OS carb but you have a REDS engine that is different. Beside that, the JQ instruction of a 0.5mm gap and tune the LSN from there does sometimes also not work on the OS carb, tolerances, different fuels and weather conditions has a lot of influence on the final tuning.
#8
Thread Starter
Tech Apprentice
Joined: Jan 2011
Posts: 96
Find the right tuning for the LSN and HSN and correct the idle when needed, the idle is basically the last one to set.
That JQ instruction is based on a certain OS carb but you have a REDS engine that is different. Beside that, the JQ instruction of a 0.5mm gap and tune the LSN from there does sometimes also not work on the OS carb, tolerances, different fuels and weather conditions has a lot of influence on the final tuning.
That JQ instruction is based on a certain OS carb but you have a REDS engine that is different. Beside that, the JQ instruction of a 0.5mm gap and tune the LSN from there does sometimes also not work on the OS carb, tolerances, different fuels and weather conditions has a lot of influence on the final tuning.
#10
Thread Starter
Tech Apprentice
Joined: Jan 2011
Posts: 96
#11
Hello boomtheroom,
You might try to check if the tank is not leaking. You need to take out the tank from the car, empty the tank, block the fuel outlet, put a long Fuel Line on the Pressure Inlet. Then submerge the Tank into a bucket of water, then blow the Pressure Line. If the tank is not properly sealed You could see bubbles coming out. Usually from the Lid Seal.
Cheers..
QUOTE=boomtheroom;16142131]Hey,
Yea tried several glow plugs and does same via remote.[/QUOTE]
You might try to check if the tank is not leaking. You need to take out the tank from the car, empty the tank, block the fuel outlet, put a long Fuel Line on the Pressure Inlet. Then submerge the Tank into a bucket of water, then blow the Pressure Line. If the tank is not properly sealed You could see bubbles coming out. Usually from the Lid Seal.
Cheers..

QUOTE=boomtheroom;16142131]Hey,
Yea tried several glow plugs and does same via remote.[/QUOTE]
#12
Hi All,
Any idea why my car is running sooo inconsistent? , idle gap .5mm bottom needle as lean as i can go without raising the idle so its too fast.. top end runs as high as it can without over hanging the revs coming back down. Just wont hold a consistent idle. https://youtube.com/shorts/lbzisG6j21k?feature=share
Any idea why my car is running sooo inconsistent? , idle gap .5mm bottom needle as lean as i can go without raising the idle so its too fast.. top end runs as high as it can without over hanging the revs coming back down. Just wont hold a consistent idle. https://youtube.com/shorts/lbzisG6j21k?feature=share
#14
Tech Regular
Joined: Nov 2018
Posts: 258
Please ignore anything 1995 Monster T says. His only 5 braincells only drink oil, the high % stuff to.
Mods still refuse to boot him so sorry about that aswell.
Mods still refuse to boot him so sorry about that aswell.



21Likes