Seattle RC Racers/North SeaTac Racing Center
#2690
just 4 weeks
#2691
#2692
Tamiya Pro Spec coming to Seatac.
whats everyone running. this spring.
I'll be adding a Mod car to the mix along with a little xpress fronty to test out. I swapped in a Gravity spec 25.5 in the Trans Am car ,a few laps on the carpet and it was pretty much dead even with a standard 25.5 . July 1st they become the legal motor for the class so why not just jump into it early. (nothing official from the club on this just the national rules)
Pro 10 will probably be a hit and miss class unless more show up. basically Pro 10 is 200mm or 235mm WGT foam chassis.
whats everyone running. this spring.
I'll be adding a Mod car to the mix along with a little xpress fronty to test out. I swapped in a Gravity spec 25.5 in the Trans Am car ,a few laps on the carpet and it was pretty much dead even with a standard 25.5 . July 1st they become the legal motor for the class so why not just jump into it early. (nothing official from the club on this just the national rules)
Pro 10 will probably be a hit and miss class unless more show up. basically Pro 10 is 200mm or 235mm WGT foam chassis.
Last edited by skypilot; 03-22-2024 at 10:08 AM.
#2694
Tech Fanatic
iTrader: (4)
Vta and 21.5
Got two 21.5 cars to test out and pick from. Thought of making the lesser my vta car but the old mason car seems good so hard to do. Hesitant.
I've got an old pro 10 car I can throw in the trunk just in case.
At galaxy this yr I plan on running gt-e and formula 1
Got a trf102 to set up and run
Id like to start getting my daughter into it. Recently got her a 3pv futaba and receiver.
She needs a rookie galaxy car and a Tacoma rookie buggy. Get her off her ipad! idk... where I'm at.
Hope your all doing well rc racers
-d
Got two 21.5 cars to test out and pick from. Thought of making the lesser my vta car but the old mason car seems good so hard to do. Hesitant.
I've got an old pro 10 car I can throw in the trunk just in case.
At galaxy this yr I plan on running gt-e and formula 1
Got a trf102 to set up and run
Id like to start getting my daughter into it. Recently got her a 3pv futaba and receiver.
She needs a rookie galaxy car and a Tacoma rookie buggy. Get her off her ipad! idk... where I'm at.
Hope your all doing well rc racers
-d
Last edited by MonkeyCmonkeyDo; 03-22-2024 at 07:43 PM.
#2695
#2696
Tech Initiate
#2698
#2699
Tech Initiate
Found a few setup sheets online, should have a decent motor/gearing baseline to start the season.
#2700
I prefer hobbywing mod motors. I am currently on a 4.5t with a 7.7 fdr. For mod batteries any quality ulcg pack works. LIHV packs last a little better in my experience.