Mugen MTX-3
Tech Fanatic
iTrader: (5)
Dremel the bar down till it fits.
Tech Master
iTrader: (4)
yea those roll bars fit above the body's roof just cut the roof abit enough to slide the roll bar in.
Originally posted by BrainTeased
yea those roll bars fit above the body's roof just cut the roof abit enough to slide the roll bar in.
yea those roll bars fit above the body's roof just cut the roof abit enough to slide the roll bar in.
Tech Adept
metal handle
hi guys,
just brought one. Running a lola shell, hence no problem.
Thanks
just brought one. Running a lola shell, hence no problem.
Thanks
New engine mount to achive higher RPM
Enjoy!
best,
best,
Tech Fanatic
Re: New engine mount to achive higher RPM
Originally posted by eddiethefish
Enjoy!
best,
Enjoy!
best,
Re: Re: New engine mount to achive higher RPM
Originally posted by Cartman
sorry but altering the angle of the engine can NO way increase RPM im affraid thats taking the piss!
sorry but altering the angle of the engine can NO way increase RPM im affraid thats taking the piss!
Tech Apprentice
Re: Re: New engine mount to achive higher RPM
Originally posted by Cartman
sorry but altering the angle of the engine can NO way increase RPM im affraid thats taking the piss!
sorry but altering the angle of the engine can NO way increase RPM im affraid thats taking the piss!
Tech Apprentice
Re: New engine mount to achive higher RPM
Originally posted by eddiethefish
Enjoy!
best,
Enjoy!
best,
Re: New engine mount to achive higher RPM
Originally posted by eddiethefish
Enjoy!
best,
Enjoy!
best,
I bet it runs better with 30 degrees toe out in the front.
I actually saw some guys using this set-up in Japan...they say it was for lower CG, nothing about higher RPMs. And they used a much smaller micro ss clutch.
Tech Adept
Re: New engine mount to achive higher RPM
reckon it won't increase the RPM, but it definitiely looks very LCG! who made the laydown throttle servo?
Originally posted by eddiethefish
Enjoy!
best,
Enjoy!
best,
Tech Elite
iTrader: (1)
looks cool anyway eddie, is that the new engine from OS (os12 tr 3 port) ur using??
Tech Elite
iTrader: (1)
don't u feel awkward when putting the glow heater to start your engine
Tech Master
iTrader: (2)
who makes that mount?
Where did you get that from ?
Tech Fanatic
I could be wrong, but I believe this is what the future MTX4 will look like... As in laydown throttle servo and laydown motor mounts... Had a friend that saw the same pic on a Japanese Forum site... Eddiethefish... Great find and post!!! Hope to see you at Crystal Park Saturday...
RC_Alan
RC_Alan