Mugen !!

hmm... I picked Kawahara for the fact that both sides of the chassis are chamferred and more cooling vent for the engine and the fuel tank.

The mugen chassis does have a nice sharp edge to it. I have thought about taking care of that.

Picked it up wrong once.. not exactly finger friendly.

NEED HELP!
 

Hello people:flaming: I am new here.:batman:

Re: NEED HELP!
 

Welcome.:)

Hi,

Which pipe/header you guys recommand for MTX-3? If you could give me the link where i can get it please? Which parts i should keep it for spare/break mostly and any parts must be upgraded?


Thanks.

Too many choices
 

which is the best chasis?????? I am too many choices... :lol:

Re: NEED HELP!
 

:confused:

I use Kawahara's Header w/ RD Logic Pipe on my Bmod RS12. :D Great result!

Re: Too many choices
 

What are your choices? :confused:

Cooling the low-end of a hot engine is one of the last 'do' if you want to have good performance on your engine, ever remember this (cold head - hot lowers). But if I need to choose, prefeer the Mugen ones with the sharp edges polished (some pics to come in short) and fingers safe.

The 4mm is much better machined than the crude 3mm stock chassis.

Re: NEED HELP!
 

Welcome aboard! you made a smart move to get rid of your expensive replacement parts car! :ha: :ha: and get a MTX3! Let's see what you can do with the new car! but first what engine are you going to put in there?

What I've been waiting for is the rear bulkhead and rear suspension arms. They are BO. Do you have any?

Here is your answer!

Check THIS out, Kawahara Delin rear lower arms. They are very strong, I had it on my mtx2 when I had the car, and it last forever!

Hi mistercrash,

I'll check if I have any; I probably do. Will get back with you later.