Problem with side belting...
 

I'm having this side belting problem that i don't know what is the cause......when i use composite pulley on both pulley(sideways) my belting ok but when i change to cso alloy pulley i'm losing the belting tooth...can someone advise how to solve this?...i'm using 25t.....is this the cause of my problem?

How are the teeth on the pulley? Aluminum pulleys tend to get sharp over time and eventually chew belts up.

But mine is a new one.....still in good condition.....

Belting problem
 

Still got the problem...playing today and yet still losing some tooth on the side belt....someone please advise....

Switch back to the composite. No need for aluminum pulleys.

ya alum are not a must.. but the xray ones have holes in between the teeth to remove dirt dust ect... maybe thats ur prob? dirt is getting stuck and making it break.. i was picked up by rc america right before they released the pulleys and have built my car already.. i drilled 56 size hole in the plastic to create the same affect..

Any others possibilities?
 

Beside dust is there any other possibilities that can make this to happen to the belt?how about uj at the front?

Aluminum sharpens, even if the pulley is new it just takes one tooth with an edge on it to ruin the belt.

CSO 2.2mm Radio Plate Carbon Chassis

Xray released the t3 gear diff with gears that fit the NT1 which are composite. 304930 is the part number, enjoy.

where do i get them from who's got them

Nexus racing usually has most parts in stock, but at the moment I would contact your local Hobby shop and order some through RC America :). Well worth the 20 or so bucks. If your still a novice or race at a track with boards you may want to put them in the rear diff only if your worried about dnf's.

Looking forward to testing this sunday if weather holds out :)

CSO New Flex Radio Plate

I have the NT1 2009 ,can I switch or swap bottom chassis 2009 to 2011 ?