I Wanted to tell you to order direct from www.bluegrooveapparel.com and he can get you fixed up. Also use AB30 code for 30% off your first order.

i know that...:weird:

If you knew that:weird: You would have already switched over to the KH's then:D

When setting the bump steer's the setup sheet says down..is that down on the spindles or down on the bellcrank site?? if its the spindles which way do the ones on the bellcrank side go?? Thanks guys

Anchorman side....the spindles should always point down. :nod:

dude...if u would stop trying to correct me you would see that i was saying me and some buddys havent had any probs with the STOCK losi bearing size on the alum hubs...because it takes out the flex of the plastic carriers...

if the plastic carriers were made with bigger bearings then they of course would be more stronger but it still would flex...but it wouldnt matter because the bigger bearing would be able to take the abuse better...

i ounly had to change 1 bearing on my rear hub and it was only because i shimmed the axail...once i took the shim out and changed the bearing it was fine..and that was mounths ago...

none of the pro-guys run the bigger bearings either...

Ya I got that thanks, but they only had red and grey, no blue.

don't you guys hate not being able to adjust your wing on the losi vehicles?
so i did some research and found this product from TEKNO rc it is a fully adjustable wing mount for the losi 8's i bought one to test out and have seen them at the track they seem to perform really well plus you can't beat their warranty if you break it they will replace it for free, check it out

http://www.impaktrc.com/index.php?cPath=22_366

Cool. :cool:

ya the fit and finish is awesome. tekno sure knows how to make their stuff

hi all , picked up my 8t 2.0 last week i noticed the manual says 2 degree toe out on the front is that on each side or 1 degree each side to make a total of 2 degrees:confused:
thanks

Generally that's per-side.

Nope....if a set-up sheet call's for say 3 degrees toe out....you put 1.5 on each side.

Its 2 on each side not 1 on each side to make 2

it depends how the sheet of written actually....looking at ALL the pro set-up sheet's...some claim it as total some are writing it per side....but as a general rule of thumb....the total # of toe is both sides added together.