Losi 8ight building and setup
#5268
that looks cool did you annodize it yourself or did you take it some where to get done?
#5270
does it cost much to have it done or is it about the same price as chroming metal?
#5271
That 8ight look's awsome anodized!!!!
#5276
Tech Champion
iTrader: (7)
I'd like to try the GMK covers sometime. For now the heat shrink I have has been on since January this year. But it is HEAVY DUTY. It doesn't really shrink. When heat is applied the inside diameter expands, grows inward. The outside does slightly shrink but not much. Also on the inside is adhesive which sticks good. It's weird but this stuff ends up being 1.8mm thick, measured with calipers. It's really thick. The one problem I had was when I first put it on. I used too long of a piece and it grinded the rear diff around the pinion bearing. The heat shrink looked like I had just put it on, but the pinion, bearing, and diff case were toasted. So I use a tiny sliver now to just cover up the cvd pins.
#5277
Tech Regular
iTrader: (1)
I have the GMK condoms on my truggy, they work fine so I will do the same for the buggy.
As for the bugs, Losi put out amendments for the radio tray install. To add o rings and use differnet screws. Or was that just for the 8T? Also adding a small spring to the throttle/brake linkage.
As for the bugs, Losi put out amendments for the radio tray install. To add o rings and use differnet screws. Or was that just for the 8T? Also adding a small spring to the throttle/brake linkage.
#5279
Any of you 8ight owner's get to drive the RC8 yet? What did ya think of it?