TLR 8ightX
|
|||
#1216
As far as my bearing being stuck I’m actually using the deep tone set up and the bearing is the bigger one that we used on the previous cars. Both bearings in the hubs are different so that’s why is so much harder to get these out is because it’s not the 8x16 it’s the 1/2-1/4 bearing or whatever. U can’t get a grip on it to pop it out easily. U almost need something the pries out to get leverage on the bearing.
#1217
Tech Rookie
You could use a heat gun to heat it up a little to get the bearing out.( I have never tried it that way just as a disclaimer) I always use one of my bent drive shafts as a tool as mentioned earlier in this thread.
#1220
Prorc.shop carries them
#1222
#1224
Tech Elite
#1225
Tech Initiate
#1226
It does not come with the Elite. The Pro.RC moves the holes back one creating a 0 hole. Totally worth it IMO.
#1228
Check out the setup sheets on TLR webpage. You might want to take a look at the rear shock tower as well. It has the 3rd row of holes for the new set up. Also keep in mind there is dremeling needed to run either the ackerman and/or shock tower.
#1229
Tech Initiate
Someone have a pic from a open Radio Box?
Don't know how to mount the Transponder in the nitro?🤔
Don't know how to mount the Transponder in the nitro?🤔