Official Team Associated Rival Monster Truck Thread
#782
Tech Addict
iTrader: (50)
To anyone interested The Dude has re-Released his a arm mounts for the MGT, EMTA, and RIVAL platforms! I have a set of prototypes from back in the day and just ordered another set! I highly recommend them for anyone no matter how you drive your rig! Way better than the stock mounts that can bend very easily just after a few small hits, binding your suspension!
Use the link that he posted on page 5 to order!
http://www.ultimaterc.com/forums/sho...=200068&page=5
Consider these like RPM arms, You really only have to buy them once!
More info:
http://www.tdracingrc.com/mgtmountsinfo.htm
Use the link that he posted on page 5 to order!
http://www.ultimaterc.com/forums/sho...=200068&page=5
Consider these like RPM arms, You really only have to buy them once!
More info:
http://www.tdracingrc.com/mgtmountsinfo.htm
#786
Tech Rookie
RPM knuckles are installed, geometry is dead on. Didn't even have to adjust tie rods.
I sure do like having the 6x15mm bearings.
The Rival/MGT axles are too short.
You have to grind the back of wheel hex to make It work.
Does anyone know if maxx aftermarket axles will mate to our CVD's?
I sure do like having the 6x15mm bearings.
The Rival/MGT axles are too short.
You have to grind the back of wheel hex to make It work.
Does anyone know if maxx aftermarket axles will mate to our CVD's?
#787
Tech Rookie
18t pinion is too much for the stock electrics on 4s. Gets to warm when doing wheelies.
#788
Has anyone upgraded there motor to the castle 2200kv? If you have is it any better, more power cooler running etc etc? I ask because I got a new one from the fs section cheap to get me going for my truggy conversion but it runs hot geared for 35mph.
#791
Thanks for the input. Just ordered one. I already have a mamba monster esc. I just wasn't happy with the reedy 1515 it ran to hot for how I was geared. Plus it was slower then my slash with a castle 1415.
#792
This was repepeatd. Sorry
Last edited by Marcis; 03-16-2014 at 09:10 AM. Reason: Sorry did a repeat of it
#793
I run the MMM2 and 2200 in mine also and its night day compared to the stock system also, this way you have the option of going crazy and running 6S.
#794
I have a big problem and don't know what to do. I picked up a hitec servo hs 7954sh. I was just about to install it. I plugged the power in to set it and the truck kept moving on its own. I shut it down and plugged the xp back in, and it stopped. I waited a few minutes and tried again. Something the wheels start to sputter. Any ideas of what's going on. And I am using mm2 motor and esc
#795
Here is the lights I added. Now I just need the new servo to work