NEW XRAY T2
02-03-2006, 05:40 PM
#2689
wonder if we could convice CRC to put that print on ozite? 
02-03-2006, 05:56 PM
#2690
Originally Posted by stiltskin
Dude, that rug is pimp!!!
02-03-2006, 05:56 PM
#2691
i tried to put my crc top plate on today and my car got tweaked worse than it ever had. found that the back screw holes were not drilled right.
02-03-2006, 05:57 PM
#2692
Originally Posted by killingtime
wonder if we could convice CRC to put that print on ozite?
02-03-2006, 06:39 PM
#2695
Tech Initiate
My crc top plate fit perfect.
02-03-2006, 08:54 PM
#2697
Nice setup, however one hit to the side and bye bye fan. I have the same fan and it seems to be fine in the stock position. If you notice the motor blows out the cooling holes and the fan setup in the manufactures stock position helps draw air out. Try temping the motor with different configurations to see what works best. Still the best $10 cooling system out there!
Here's my cooling:
http://webpages.charter.net/stone10473/T2%20007.jpg
http://webpages.charter.net/stone10473/T2%20002.jpg
The only problem with this setup is that you need to cool the hood not the can...
Here's my cooling:
http://webpages.charter.net/stone10473/T2%20007.jpg
http://webpages.charter.net/stone10473/T2%20002.jpg
The only problem with this setup is that you need to cool the hood not the can...
02-03-2006, 09:02 PM
#2698
The p-dub bumper for the T2 still isn't avail. on their site. Anyone have any news on that?
02-03-2006, 09:07 PM
#2699
The only problem with this setup is that you need to cool the hood not the can...
hhhmmm... I just ran it tonight and it dropped the hood temp by about 20'F.
Any cooling seems better than no cooling. Also you have to consider what part of the motor desipates heat quicker.
By helping draw air out of the can the way it was designed also helps draw more air in.
Whether you push or pull you still move it and cool it.
hhhmmm... I just ran it tonight and it dropped the hood temp by about 20'F.
Any cooling seems better than no cooling. Also you have to consider what part of the motor desipates heat quicker.
By helping draw air out of the can the way it was designed also helps draw more air in.
Whether you push or pull you still move it and cool it.