NEW XRAY T2
#1651
the way i understood it is:
Set ride height to 4mm
Jam a ride height gauge under each side of the chassis at the rear to 5mm.
Adjust droop screws until wheel just touches the board.
repeat for the front.
Just seems more accurate it you use 2, not sure how accurate doing it by sight would be.
Set ride height to 4mm
Jam a ride height gauge under each side of the chassis at the rear to 5mm.
Adjust droop screws until wheel just touches the board.
repeat for the front.
Just seems more accurate it you use 2, not sure how accurate doing it by sight would be.
#1652
Tech Apprentice
Originally Posted by ChadCapece
After hours upon hours of spying and infiltration, I have concluded that you are getting an Xray.
#1653
Tech Regular
That will work.
#1654
Tech Apprentice
besides, atleast i gave you something to do.
#1656
RW Gears now available www.pdubracing.com
RW Gears are direct bolt-on for both Xray T2 & FK05 Same gear to win Cleveland
RW Gears are direct bolt-on for both Xray T2 & FK05 Same gear to win Cleveland
#1657
Tech Elite
iTrader: (21)
Originally Posted by DRKWNG
What is the best piston to run in the shocks? the adjustable's, two, three, or four holes?
#1658
John_Stones - nnick posted a page or so back that he had some kits available, you might try PMing him, he's located in Greece.
#1659
Tech Apprentice
Originally Posted by John_Stones
Ok my preorder got messed up. Anywhere in the UK have any kits in stock?
#1660
Originally Posted by tofuburger
Damn Robert thats a good idea. i think thats a lot easier then grinding screws down. will try counter sinking tonight. do you guys know if rear hub carriers with fixed toe are going to be made for the rear? i really dont like how toe is set with spacers this binds the rear arms.
#1661
FYI,
The new T2 battery strap part# and the gold/silver spring rate info can be found in the XRAY forum T2 thread.
The new T2 battery strap part# and the gold/silver spring rate info can be found in the XRAY forum T2 thread.
#1662
Would someone measure the width of front and real bulkhead, outside-to-outside.
T1FK04 is about 42mm outside-to-outside, both front and rear bulkhead.
T1FK04 is about 42mm outside-to-outside, both front and rear bulkhead.
#1663
Originally Posted by ttso
Would someone measure the width of front and real bulkhead, outside-to-outside.
T1FK04 is about 42mm outside-to-outside, both front and rear bulkhead.
T1FK04 is about 42mm outside-to-outside, both front and rear bulkhead.
I have to ask, why???
#1664
Originally Posted by BritRacer
You got me.
I have to ask, why???
I have to ask, why???
#1665
whats the point?