3 Racing Sakura D3 CS Drift
#811
they take a while as they're couriered by donkey across the Himalayas then sent by homing pigeon to the hong kong postal centre lol
the magnets don't need a guide either they want to sit perfectly aligned on each other my only issue is how to mount to the body as I'm sure they will pull off the shell.
the magnets don't need a guide either they want to sit perfectly aligned on each other my only issue is how to mount to the body as I'm sure they will pull off the shell.
Last edited by pickled; 12-08-2012 at 05:56 AM.
#812
#813
#814
#816
Tech Regular
iTrader: (3)
Adjusting the preload helped, but now it is almost at the bottom. eunique, what load spring did you change to? I have some for my Zero I maybe could use.
What about bodyposts? you all have them going trough your body?
And what about toe in the front. Mine is a bit toe out. Is it suposed to be that way?
What about bodyposts? you all have them going trough your body?
And what about toe in the front. Mine is a bit toe out. Is it suposed to be that way?
I just went by "feel" and it was closest and slightly stiffer than the D3 CS stock springs
I tried toe out in front..then read that 0 toe is what you want for drifting...so I reset it to 0
#818
Tech Initiate
Im not quite sure of specs of the springs...from an Integy set for Zero...I used the gold ones they came with the set.
I just went by "feel" and it was closest and slightly stiffer than the D3 CS stock springs
I tried toe out in front..then read that 0 toe is what you want for drifting...so I reset it to 0
I just went by "feel" and it was closest and slightly stiffer than the D3 CS stock springs
I tried toe out in front..then read that 0 toe is what you want for drifting...so I reset it to 0
I have that set. The gold is "medium"
Do you feel a difference with 0 toe in?
#819
Tech Regular
iTrader: (3)
http://www.integy.com/st_prod.html?p...217&p_catid=12
Billet Machined XSR7 Shock Set for 1/10 Touring Car & Drift Car (L=56mm-59mm) C23831LIGHTBLUE
...so I used these gold springs from that set...the black ones I use on my Zero S.
I believe its a little more predictable with the 0 toe..but you will have to experiment and do practice runs because the whole car gets affected with suspension tweaks
#820
#821
Well I just finished farcry 3 awesome game.
#822
My KPI and C hub delete mod in one... Still needs adjusting but it's getting there
#824
Tech Apprentice
#825