Yokomo MR4TC-BD
#8596
Tech Elite
iTrader: (120)
Hi i want ask you which shock end you use?because when i use short(16,4mm)... car heigt in front is 3,5-4mm
when i put there long susp.end(21mm) is ok but suspension work very small...
now i have front/short - rear/long
i can cut long shock end... but i want only ask you what you use you...
i have Masami special
now i make setup for carpet race with foam tyres
when i put there long susp.end(21mm) is ok but suspension work very small...
now i have front/short - rear/long
i can cut long shock end... but i want only ask you what you use you...
i have Masami special
now i make setup for carpet race with foam tyres
f you use the high volume shock bodies,( which i think most of us are using) you can use short shock ends, also make sure your shock lengths are at least 63mm, you can optian the 63mm with the stock shocks and short shock ends by unthreading the sock end.( but you will only have a few threads of the shaft in the shock end ... very risky......
#8597
Tech Elite
iTrader: (2)
I have been experimenting with soft spring setups and found a good combination with the yellow progressive springs in the front and green rayspeed in the rear...
My usual spring setu up is Pink progressive front with Blue progressive rear..
All setups are using masami rear shock tower.
My usual spring setu up is Pink progressive front with Blue progressive rear..
All setups are using masami rear shock tower.
#8598
i will use HPI gold - front and HPI silver rear
#8602
Which steering knuckles and rearhubs you got?
It is very important to have non-trailing 0mm knuckles and 0degree rear hubs
We usw plastic steering knuckles anyway as alloy is very heavy and is as huge increase in umsprung mass not very healthy for the handling
+ plastic is ok or broken. Alloy bends
It is very important to have non-trailing 0mm knuckles and 0degree rear hubs
We usw plastic steering knuckles anyway as alloy is very heavy and is as huge increase in umsprung mass not very healthy for the handling
+ plastic is ok or broken. Alloy bends
#8604
0deg rear hubs are ok but please notice that these hubs are 0,5mm lower (2mm under ballstud with plastic = 2,5 with alloy)
If u use sd-010rw shafts, glue the inner bearing into the Hub to reduce angle-slop
And use sd-415s steering knuckles
If u use sd-010rw shafts, glue the inner bearing into the Hub to reduce angle-slop
And use sd-415s steering knuckles
#8605
Hello!
I'm thinking of buying Yokomo MR4TC BD Masami Edition, is this car still worth it's price? How does it compare to TC5 or t2 007/008? Do parts break often? Weak points?
I'm thinking of buying Yokomo MR4TC BD Masami Edition, is this car still worth it's price? How does it compare to TC5 or t2 007/008? Do parts break often? Weak points?
#8607
on ebay they show from time to time NIB.