Tony Vega

iTrader: (8)

Is there a way to re-name the individual profiles?
I'd like to re-name then so they are easy to distinguish between GP3300's, GP3700's, and 5 cell receiver packs.

nnick

iTrader: (1)

Check page E3 from the manual at the bottom

At the profile you wish to change hold 3secs button ->
The first character starts to flash. With up and down button change letters/chars with <-, -> change position

Hope that helps

Nick

jas

Are the fans seem excessively loud on this charger?
I mean I've used other chargers including LRP Pulsar2, Duratrax ICE, CDC/Integy (also has dual fans), none of them make such loud noise as my Cell Master.

Merciless

Just got mine today , Playing with the CTX charge mode . Anyone got a good CTX profile for GP3700's when using them in 1/12th.

I think the NEXUS profile might well be alittle aggressive when trying to get an 8t motor to go 8mins with 4 cells .... (i usually go with a straight 4amp linear)

I have to agree those fans are well noisey but there small to need the high rpm to move the amount of air a larger fan can at a lower rpm. I guess it was all about keeping it all in a small package that lead to the small high speed fans being used .

Oh well just testing and playing with it at the moment ........

nnick

iTrader: (1)

Oh yes they are loud

Try to discharge a fully charged battery

Other than that it's a great charger.

Nick

acutts

Has anyone used the battery warming tray with the CELL MASTER? Is this to warm the cells before charging in cold temps???

sosidge

Although I haven't used one, that is what the tray is for.

Mr. Shookie

iTrader: (9)

Yes,,,,,it works great...
But read the Cell Master instructions so You don't over heat...
-SHookie <><
Its almost cold enough now but not quite yet...
Another month and it the warmer will be needed...

Doomah

hi.

anyone know if we can power tire warmers or a rayspeed discharger from the output outlet?

also i lost my manual, the delta peak figure, is that refer to "mv per cell" or total?

nnick

iTrader: (1)

You can download the manual from here

You can power up much more warming tray and much more fan, I'm not sure if it's adequate for tire warmer

Nick

Doomah

hi my charger is false peaking. here are the details

Gp3300 matched cells. I have dishcarged and trayed them.

I charge at 5.5amps delta peak at 3mv.

I set time lock out to 1:00, so it doesnt flase peak within the first minute.

I go to charge at 5.5amps, the voltage of the pack goes to about 8.5v and the voltage drops for about 5 seconds. (can see the arrow pointing down). it then says *Peak Cut* and stops charging

I have change Time Lock out to the default 10:00 but it still false peaks within the first 5 seconds.

ANy Ideas?

Thanks

JasonC

iTrader: (120)

anyone know what the diffrence between softe ware version 1.0 and 2.0 on the MM CTX charger is ??

Doomah

wah... ctx2 is out? i just bought a ctx-c. is it upgradable?

Alex_kipper

iTrader: (1)

you have to hold the > key till you see a key sign on the charger, this means there is a lock out...




I didnt know there was a V2.0 cell master

nnick

iTrader: (1)

If you want to use the lockput function you should use way more than 1 min!! It's no use if you set it so little. Usually is 10 minutes

CTX ver 2??? That's new.. Are you sure about this?

Nick