Team Associated TC6 Thread
#999
Tech Adept
Just made my first rollout on Sat. and Race on Sunday
All was fine,
just shorten the Weelbase in front
lower the Rollcenter to 1 Point
installed less toe-in in the rear
driving 6-6 drop
changing 600 MuchMore Oil
and testing Caster Block 6decrease (not sure if its good)
driving yokomo gear in the rear
Track was indoor tarmac (Western-German LRP Masters Race) very high grip.
car was good with little less steering caused by tire overheat.
Q Pos. was 2 Final Pos. was 2
will post my setup tomorrow
Greetings
Thilo
All was fine,
just shorten the Weelbase in front
lower the Rollcenter to 1 Point
installed less toe-in in the rear
driving 6-6 drop
changing 600 MuchMore Oil
and testing Caster Block 6decrease (not sure if its good)
driving yokomo gear in the rear
Track was indoor tarmac (Western-German LRP Masters Race) very high grip.
car was good with little less steering caused by tire overheat.
Q Pos. was 2 Final Pos. was 2
will post my setup tomorrow
Greetings
Thilo
#1002
Tech Regular
ok here you go
arms
castor blocks
steering knuckles
rear hubs
cva's
6x10 bearings
diff bearings
hinge pins
wheel hex's
I think that is most of it
arms
castor blocks
steering knuckles
rear hubs
cva's
6x10 bearings
diff bearings
hinge pins
wheel hex's
I think that is most of it