question?

is this kit lighter than the evo3?
the cover of the diff. seals of any particles from getting in?

Its either the Strat 2.0 or the Ride Stratus

Its the proto stratus. I know, I've got one (or two)

Supposedly it is lighter, but nobody's actually come back with any figures. I can't give any as no evo 4 yet.

Personally, I would always run with the diff covers. You never know what you're going to pick up in a race, even when you're in a supposedly 'clean' environment.

If you ditch them on the basis of weight, then you are already struggling.....

Fully loaded up with Ti screws,Alloy front ring gear, alloy imput shafts, alloy transponder/servo mount,VFS2000,Ko Propo 301 reciver and Futaba 9550..with body motr ect ect...
1480grams...with transponder in the car right at 1500grams;)
-Dave:sneaky:

so the car is quite heavy if you consider all the optional parts that you have in the car to achieve that weight. Not surprising at all seeing the number of screws...

The Alloy up rights do weigh a bit.... but ..it comes to the weight limmit that I race at so ...it does the trick for me:sweat: :D

there are places to drop weight from the EVO4 though..;)
-Dave:tire:

mine came in at 1460

A TB Reunion...
 

My new "baby" has arrived... (thanks Chris/Jeff!!!) Hopefully I can get this thing done by this weekend... :nod:

Re: A TB Reunion...
 

Ian, Tamiya this Saturday?

Jeff... will sit this Saturday out. There's several big races this coming August, and I need to take a break first before diving head on... will probably practice for KO next week. I know Chris will be at Tamiya this sat though... you guys have fun!

OK, I've given in and ordered one with a Ti kit. When I know some numbers, I will post them:blush:

Ours (when it gets here) will have a hitec HFS35 receiver and a Quantum speedo, that, with Sanyo 3000HVs should bring it in at 1460 with the TXP:sneaky:

Just wondering if these will fit on an Evo IV, I wanna get some for the simple fact that blue is good ;)

http://www2.towerhobbies.com/cgi-bin...?&I=LXETM4&P=0

yes..they should fit with no problems...std. diameter body post..