Xray XB2 2WD Buggy Thread
|
|||
#4396
#4397
you guys know the first rule about fight club?
#4398
#4399
Don't understand this. Does this mean more steering at high speeds,as in 3/4 throttle sweepers? For cornering my xb2's both had way more steering with the long bushing on top. This is for lower speed turns all the way thru to getting on the gas on power. Couple others at my track too. Just me?
#4400
Tech Elite
iTrader: (27)
Don't understand this. Does this mean more steering at high speeds,as in 3/4 throttle sweepers? For cornering my xb2's both had way more steering with the long bushing on top. This is for lower speed turns all the way thru to getting on the gas on power. Couple others at my track too. Just me?
#4401
#4402
Tech Elite
iTrader: (27)
Here it is for all those curious.
http://forum.teamxray.com/xform/inde...setup=xb2_2016
#4404
Tech Addict
iTrader: (7)
Always, there's the setup that's on the sheet and the one that's on the car... for instance, i always set a base ride height and then adjust it on the track to fine tune steering/traction balance before the race, so final ride height could be a mm or more different from whats on paper
#4405
probably due to his style of driving and carry over from the D216 he drove in a rather plush config compared to other cars. D216 is rather extreme in design and different compared to other cars. TLR, YOK, XB, AE, etc differences are few allowing alot to be shared.
#4406
.
#4407
Tech Elite
iTrader: (33)
the shock oil is a base.. if you feel it should be lighter.. by all means.. go lighter.. in the end.. everyone has different driving styles.. and different setups.. go put the car on the track.. get some base lap times.. make changes.. and run again.. see if its faster.. or not..
#4408
Tech Apprentice
iTrader: (1)
First build
Hey Guys, I'm in! My wife got me the 2017 xb2 carpet kit for my birthday. The guys run indoor on green outdoor carpet you would normally see in a gazebo and they run with no compound.
I am thinking this will be either medium or low traction? I have a sc5m sc and it will do traction rolls unless you run 32.5k oils or higher in the shocks.
In my stadium truck I run mini pins in the back and stagger ribs in the front. Should I run the same on my buggy? Thanks and excited to join the club!
I am thinking this will be either medium or low traction? I have a sc5m sc and it will do traction rolls unless you run 32.5k oils or higher in the shocks.
In my stadium truck I run mini pins in the back and stagger ribs in the front. Should I run the same on my buggy? Thanks and excited to join the club!
#4409
I need some help with my shocks. I cannot assemble these things without getting tons of tiny air bubbles in them. In my xb4 they are perfect but when With the xb2 I'm getting a lot of tiny bubbles even just after moving the shaft up and down by hand a dozen times. Should I replace the orings in the bottom of the shock body or something?
#4410
R/C Tech Elite Member
iTrader: (1)
I need some help with my shocks. I cannot assemble these things without getting tons of tiny air bubbles in them. In my xb4 they are perfect but when With the xb2 I'm getting a lot of tiny bubbles even just after moving the shaft up and down by hand a dozen times. Should I replace the orings in the bottom of the shock body or something?
http://www.rcdriver.com/understandin...ladder-shocks/