190mph

iTrader: (12)

Yes they will

racingnewb

iTrader: (7)

Has anybody tried the lower front/rear arm anti twist bushings? I know PSM makes them and possibly revolution designs. I was looking into them for my T3, thanks for any input

KCodd

iTrader: (2)

I've run them and they didn't seem to make a huge difference. They did cause a bit of binding in the arms but a reamer could fix that.

iroczcec

iTrader: (140)

does anyone have any tips to tighten the rear up on my rc8b3e I am running on a big outdoor track with low grip I have a black sway bar on the front blue on the back 7/7/3 diff 37.5 in the front shock 32.5 rear ride height 27 front and rear but when I go around a turn and get into the throttle it want to keep going around I have cvd and v2 diffs yellow springs on the front and either green or blue on the rear any help would be appreciated thanks

PorTX

iTrader: (4)

This may not be the way everyone does it. But I would, try more rear toe in, first. Then up the rear diff oil if you need more.

ravage

iTrader: (15)

I am using 50 in the front 45 in the rear, white shocks all the way around I have my ride height at 27 as well I have my rear camber link the 2 hole as of right now, i might move it up to the 3.

racingnewb

iTrader: (7)

5k in rear diff, move rear camber link next, shortest wheelbase in the rear.

Cday

iTrader: (7)

Anyone running the hobbywing xr8 motor and esc? My motor overheats like crazy.. I've tried different pinions from 14t to 17t but nothing helped. I have a 15t on it now. Motor spins free and so does the drivetrain. Bearings are good, solder is good(even re soldered and shortened the wires). Its overheating so bad i can maybe go 9 minutes if i dont have a heatsink and fan on it and even with the hs and fan it will thermal at around 14 minutes so thats cutting it close in an a main with practice laps. If anyone has any input.. thanks

KCodd

iTrader: (2)

Which motor? 1900 or 2250?

KCodd

iTrader: (2)

Does the drivetrain spin freely when you have no pinion? What are your diff fluids?

Cday

iTrader: (7)

Its the newest 1900kv and yes its free when the pinion is off. Running 5/5/3 in diffs. Esc doesnt get very hot its just the motor and its about a month and a half old. I also drilled holes in the body for air flow and it didnt really change anything.

KCodd

iTrader: (2)

Call them up because it needs to go in. I just lost a tekin ESC so don't feel bad. Look into SMC 1900. They're $70 and really good motors.

MX304

iTrader: (21)

Do you have the thermal shutdown enabled in the esc, or are you checking the motor temp directly with an IR thermometer? I have found the Hobbywing thermal protection shuts off WAY before the motor is actually too hot. I always disable it and measure the motor temps.

Cday

iTrader: (7)

Well im afraid to turn the thermal protection off because i know its overheating because it will melt your skin on your finger if you hold it on there lol i have an smc 1900 i just want the hobbywing stuff to work. Ill call up hw i guess and put in my backup smc 1900 thanks guys

hardijs

does other brand lowewr front arms fit instead of original B3.1 arms?
need to go to race with new just built kit with no spare front arms, as those are out of stock, so curious if some other brand front arms could fit...if some need ocurs.