R/C Tech Forums

R/C Tech Forums (https://www.rctech.net/forum/)
-   Electric Off-Road (https://www.rctech.net/forum/electric-off-road-4/)
-   -   Team Associated B4.2 Thread (https://www.rctech.net/forum/electric-off-road/694124-team-associated-b4-2-thread.html)

3srcracing 11-18-2013 02:09 PM

For anyone interested I have the Avid Tray that would sell/trade for something. (Brand new never used)

Grasschopper 11-18-2013 05:23 PM

I have a Lunsford camber/steering link kit that I'm going to install...it came with ball cups. Are they any good or should I not bother and just use RPM or the JConcepts kit I have?

5th wheel 11-18-2013 06:09 PM

Will the xerun v3.1 hobby wing fit into the b4?

Wildcat1971 11-18-2013 06:21 PM

how do you want to mount it? I gave you a suggestion. if you want to mount it on the side, the wires might get in the way of the body, so I would try and face the switch left and the wires towards the back. you will also need to take the fan off for a side mount probably

rc car guy 11-18-2013 06:28 PM

so i have a question about roar legal battery strap can anyone give me the specific location of that rule?

scottie_smith 11-18-2013 11:15 PM


Originally Posted by silveraider14 (Post 12736232)
I think the 6 but have to double check later

Cool thanks...Just hit me up when u know. I would think 7 inch would be way to big though. It says it is for mid motor cars

2-shot 11-19-2013 04:33 AM


Originally Posted by 3srcracing (Post 12736345)
For anyone interested I have the Avid Tray that would sell/trade for something. (Brand new never used)

Man!!! I wish I would have known! I ordered one last night!
That's how it goes for me - a day late and a dollar short!! LOL!!

5th wheel 11-19-2013 05:21 AM


Originally Posted by Wildcat1971 (Post 12737137)
how do you want to mount it? I gave you a suggestion. if you want to mount it on the side, the wires might get in the way of the body, so I would try and face the switch left and the wires towards the back. you will also need to take the fan off for a side mount probably

You can't mount it that waY because of where the sensor wire goes in behind it down to the bottom you can't push it that tight up against the battery pocket

Wildcat1971 11-19-2013 05:36 AM

my sensor wire would work, but non the less. you could also mount it with the wires towards the battery, sensor wire forward and switch back or try and low profile mount the wires.

5th wheel 11-19-2013 06:19 AM


Originally Posted by Wildcat1971 (Post 12738265)
my sensor wire would work, but non the less. you could also mount it with the wires towards the battery, sensor wire forward and switch back or try and low profile mount the wires.

Okay thank yOu. I will study on it some more if you have a picture that you could post of this in your car that would be helpful assuming that you have the b4.2and the xerun v3.1 thanks for the help and info

5th wheel 11-19-2013 06:20 AM

If all else faIls I may have to put it on a center shelf some now

TheRcworld101 11-19-2013 07:05 AM

Everyone says I need to run the c4.2 conversion on a medium to high traction track at our track is this true or can I still run rear???

rc car guy 11-19-2013 07:22 AM


Originally Posted by TheRcworld101 (Post 12738455)
Everyone says I need to run the c4.2 conversion on a medium to high traction track at our track is this true or can I still run rear???

i am running rear motor with a gear diff and sway bar, on ozite high bite carpet. The others in the buggy class are running the same, the one guy who was sponsored, was running a kyosho rb6 (mid motor), hes very good outside, but inside we were just as fast as him, and most of the time more consistent i can send you my set up, however each track is different. I have made this statement many times and i am sure I will say it again. Until a mm comes and whoops up on me by a good amount on a track i run at, then i shall stay rm.

hobbyten 11-19-2013 08:03 AM


Originally Posted by rc car guy (Post 12738494)
i am running rear motor with a gear diff and sway bar, on ozite high bite carpet. The others in the buggy class are running the same, the one guy who was sponsored, was running a kyosho rb6 (mid motor), hes very good outside, but inside we were just as fast as him, and most of the time more consistent i can send you my set up, however each track is different. I have made this statement many times and i am sure I will say it again. Until a mm comes and whoops up on me by a good amount on a track i run at, then i shall stay rm.

What tires are you running on the carpet?????????

rc car guy 11-19-2013 08:24 AM

Proline subrubs clay compound with red aka foam front and rear we are using a brake clean that doesnt leave a greasy residue and sometimes we are doping our rear/front tires depends on the traction we are using sticky fingers I used dope once my rears went bald. I stopped once I had too much rear traction. Traction went down last week so I started again. Only partial though


All times are GMT -7. It is currently 03:25 PM.

Powered By: vBulletin v3.9.3.9 Patch Level 3
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.