i was just looking at that and amain has them under electric motor assesories.
and with my 550 i run a 12 tooth pinion

Thanks I am pretty close to what you have. What pinion and temps do you have?

FYI
 

I have these available for the SC10 4x4 as well. PM me if you would like a set!

http://www.rctech.net/forum/r-c-item...ml#post9415386

I dremeled out the wall in front of the motor to run the wires. Gave me enough room to cram a castle fan in there and only has an 1/8" air gap where it hangs off the end of the motor, but I think I'll go with a heat sink instead. There's a little over an inch of bare can showing. I don't like fans if I don;t need, extra wiring plus crap to break, and harder on the BEC.

http://i610.photobucket.com/albums/t...MDg5LmpwZw.jpg


Does anyone want my tekno hexes? I think I want to go for the FT ones instead. These are nip with shims and pins plus an extra set of traxxas pins, $15.

to the guys who have their receiver way up front close to the servo. where do you leave your antenna wire ?

im using a 15t pinion, and the odd thing is the temps seem to vary from day to day, sometimes 140ish up to 180 after 10-15 min.

Does anyone know where I can buy a heat sink for my LRP SXX Comp V2 Speedo? I wasn't sure if there was any replacement heatsinks for the TC Spec that were available.

I'm planning on running my LRP Comp V2 with a Trinity 4x4 5.5 550. Thanks.

Would this be it? https://www.ssl-stormerhobbies.com/c...ns&pn=LRP82700

I was told that package was made for the Sphere, and was too big for the SXX. Thanks for looking out.:D

The D3 is nice. I run 13/62 w/my SC4X 4.5 and a 14 outside on a large track. My V1 throttle profile was 5. I have a V2 TC Spec coming...plugged my V1 in backwards :( It looks like guys are running a throttle profile of 2 or 3. The V1 and V2 have different settings.

Are you guys saying the Belt tensioner pulley (91013) has a front and back? I have mounted my front one both ways with no issues.

I am going to guess the guys with belt issues are running the clicker locked? I use the clicker and have not had any issues racing




murky123: I use the blitz antenna mount in that spare hole in between the front chassis and the mid chassis

Anyone have a good base set-up for a tight, loamy track, with many small bumps? I've looked on the AE site, but nothing really matches for this truck

Walt Henderson's setup on the AE site should get you into the ballpark.

AE shows stock on the FT shock kits and all the springs. :D

I'm having a hard time justifying spending $9 on shipping to order a $5 spring, let alone $130 for front and rear shocks that probably wont make my truck handle any better.

Can anyone explain the performance difference between the stock and FT shocks one would see?