MX304

iTrader: (21)

You can make something very similar to an Outerwear out of certain types of kite material.

BlackStarRacing

iTrader: (40)

i am actually in the process of making a more affordable breathable cover for around $10 shipped....im finishing up design and testing hopefully this week... I run on loose clay and always end up with it all over my electronics... So give me the week to finalize design and i will post pics of it!!

chucko

iTrader: (3)

For losi SCTE using 8 shocks Red front 35 w oil #54 rear silver 27.5W #54
hope this helps

ChrisAttebery

iTrader: (121)

Can someone tell me where the 5x10x4 bearings are on the truck? I see them on the parts listing, but can't find them anywhere on the drawings.

Thanks,


Chris

KingdomRacer

iTrader: (5)

f/r diff pinions

KingdomRacer

iTrader: (5)

+1 Only change for me is #55 pistons

ChrisAttebery

iTrader: (121)

The drawing shows them as 5x11.

hacker07

iTrader: (13)

Chris,

They are on the listing as that came from the TEN-T and those bearings are in the ROSS unit and that line never was removed from the listing.

KingdomRacer

iTrader: (5)

you are right
read that post too fast

ChrisAttebery

iTrader: (121)

Thanks Ryan!

m2cracing

M2C RACING IS PLEASED TO ANNOUNCE THE RELEASE OF OUR 58MM INNER HINGE PINS.
these pins are made of o1 tools steel and hardened for long life.
Nichel coated for added durability
We will also be releasing the 59mm model in the next few weeks for the rear
toe system as we understand that the 58mm are popping out on when you set
your toe wider.
part no. m2c7126
www.m2cracing.com

elex300

iTrader: (110)

Lots of option parts coming out lately. These look nice.

http://www.shortcourse.eu/2012/05/te...-option-parts/

Lon_L

iTrader: (9)

Might have been mentioned earlier, but I just went to install my new APE Tray only to find out that the rear battery holder hits the TLR torque rod on my Tim Bump Chassis. For it to work with that combo the rear mounting holes would need to be offset about the same as the fronts.

Really nice piece though Chris. I will hang out to it and see if I can use it in the future.

bparanoid

iTrader: (1)

Never-mind already answered...man your guys are good!

LOSA6954 - 5X10X4 sealed bearings used in front and behind the clutch bell on the Nitro Ten-t motor. Shows up on the exploded view for the Ten-t.

I've seen strange things on all the SCTE's, Ten-t's & 810's parts listings.

hacker07

iTrader: (13)

I would have to take the blame for the 810 and SCTE parts listings as those have been mine. Usually have all of about 4 hours to look them over though, lol. Sorry Guys.