as far as the tire subject goes...this is what i do.
trim a TINY bit off the bead of the tire.
cut a small amount off the foams at a 45 degree angle.
take some sandpaper to the rim where the tire bead sits.

just my .02

Orion 5500 fit like a glove
 

i have the orion saddle 5500mah with 90c and max burst is 150 they fit lie a glove have had know issue with them a little more than i wanted to spend but trust me well worth

no more problems with my shocks
 

i got new shock shafts and went through them and it turns out that the TA e-clips popped off again so i went back to the other e-clips i hate to have to say it but the e-clips that got me through a whole weekend of practice and racing on a 1/8 track and its a shame to say the e-clips that worked were TRX but it has held up to some insane abuse and there still running fine

My B44 seems to stutter when I am driving it with very low throttle. This is my first 4 wheeler so not sure if this is normal or not. Thoughts?

Not normal. Check the sensor wire and connections.

I'm running orion r10 pro and a reedy sonic 6.5 turn

just got some parts and ballast weights wondering where to place the weights haven't really found any info on placement or how to know where to place them is there a way to find out where to place them

the ballast weight screws into the chassis, in between the saddle pack, some guys put 1/2 oz in between the speedo and the battery on the left side of the chassis as well.

have the counter weights too
 

i run orion 5500 carbon pro and a tc spec esc a x-20 motor hitec 7940 servo where would i place the counter weights and is the a way to to know where to place them

Don't use the bullets that come with the packs. Pick up some duratax 4mm bullets. I have seen people use those crappy bullets on reedy packs with the same result. After switching no more problems of melting.

can anyone help me out on a good basic esc setting to start adjusting my esc. Im running a MMP with 6.5 tiken motor. Do most ppl run any drag? Thanks

not sure if this helps
 

i usually run between 2 and 4 drag depending on track layout if it has long straights and sharp turns i would recommend 3-4 smaller tracks and not as fast of a track then 2-3 but it all depends on your driving style what i would recommend playing around with the settings until its fit your drive style when your at the track ask around and and see what other ppl are running and their advice you won't get the same answer but start out with a little higher drag and take some off as you get more comfortable

If you guys know anyone who is looking to get a 44.1 i have one for sale with Kyosho BB's and other crap
http://www.rctech.net/forum/r-c-item...tor-tires.html

I have kyosho BB spring for the 44.1 if anybody is interested, yellow and gold for the front and white for the rear

Ya will do i just switched over to low pro bullets solderedright to esc. now i gotta do my sc10 4x4 thesame