[QUOTE=UN4RACING;10437919]Thanks man! Can you tell I work in the engineering field? ;)

[QUOTE=burgboyz;10439045]Whens the new baby due..LOL

[QUOTE=TJMac;10441215]Your a pro dude. Friggin Sweet.:nod:

Dude yours is just as clean as mine is. In fact, I like how you routed your battery leads better than how I did mine (I did the Deans and am regretting it, they're simply not needed).

[QUOTE=UN4RACING;10441224]Tomorrow!

Luv the switch location and wiring job on yours RacerX!
Cya Tuesday!?

Thanx. I appreciate it. I could take the top plate off some time and shoot it. But I used the flat sensor wire. I put down some Losi servo tape and laid all the flat wires on it, then took black servo tape and covered it. Its low and tight and wont budge. The black collects dust but is hidden. Yours is much cleaner. Next kit I am going to go the extra mile and replicate yours. These B44 kits are tough to hide wires. And be able to pull the top plate on the fly. Yours is dialed.

[QUOTE=burgboyz;10441261]That location I have found to be pretty safe as far as a T-bone or marshal shutting it off. On switch forward BTW.

BTW if you ever run yours that way on the battery. make the jumper a bit long. It helps for pulling and re-installing them.

Heres Mine with the Big Bore Setup
Reedy 6.5
LRP TC Spec V1
JC Barcodes V2 Rear
JC Barcodes V1 Front
:sneaky:

whats a good motor
 

i am unpacking my B44.1 and looking into the motor and electronics to buy i am leaning towards LRP sxxx TC model,a rs pro ,or the new orion vortex not to sure what motor would work out best and also what turn would be good to get started with no newbie to rc been racing carpet but i am just getting into 1/10 buggy looking for some recommendations any input will help

just finished mine and i put a lrp esc with a lrp 6.5 and the thing is a rocket ship, even with no boost

What type of batteries fit this best. 25-40c.

hows the temps.....
 

on a 8 min run time about how hot does esc and motor on a medium to large track get i don't need exact temps just like a range what spec esc is yours and so you mean reedy 6.5 ??

mybad man i always consider lrp as reedy
 

i can't find a 6.5 lrp and haven't heard much about them and what spec esc

its a lrp x12 6.5.....and the esc is a lrp TC spec...havent made it to the track yet but screaming the thing up and down the street for 5 minutes the esc temp was around 97 and the motor was about 111...im running a 18 81 right now but im going to go down to a 17 or maybe even a 16...it pullls very hard on top and the bottom is snappy right now....i know its going to make it even more snappy on bottom but i can adjust that in the throttle curve expo