AL3xGR

I'm pleased with my Hobbyking 150A car esc with a Novak 4.5T 550 motor.

EDIT;On 2s lipo it's not even warm.26T pinion.

EDIT_2;Get a Xerun ESC if you think the RX8 is too expensive for you.(Hobbyking 150A car esc and RX8 have the same MOSFETs - and maybe Xerun too)

jeffrobmx

iTrader: (7)

i run the xerun 5.5 turn 540 can with the 80 amp speed control
using 3.75 deg of timing this truck is wayy fast had to back down the controller also motor does not reach 90 deg and the speed controll is always under 75 deg these tems were taken after a 10 min main

Cappy

iTrader: (16)

I dont understand why you guys need a 550 motor in it for. My Tekin Redline 8.5 540 can is plenty of power with an RS PRO on 2cells.

rustler1995

iTrader: (29)

how does this thing do on the track?

any runnning videos?

Cappy

iTrader: (16)

This lil truck is awesome on the track !!

rustler1995

iTrader: (29)

good to hear! ive actually been looking into them.

sweet little trucks id say!

1Fastpede

iTrader: (53)

well as i said i loved my 10.5 540 tekin motor. but after numerous failures form ballistics and the tekin i opted for the 550.

Oasis

iTrader: (38)

Their are quite a few videos out there, it's on a different web site..

Slash65

iTrader: (8)

If you look through some of the older posts you will find some videos as well...

Slash65

iTrader: (8)

I finally got around to taking some pictures before it gets dirty...

rfleck

iTrader: (58)

I just picked one up on Friday.

I changed the layout a littlle by moving my battery forward and tucked the Esc behind. will report how well it works. I did this before with a Jammin SCRT10 and it worke really well.

Anybody done this and not liked it? Hopefully it doesnt jump too nose down.

Lason

iTrader: (1)

I picked one up today, I watched them go around the track and was sold on them. They were flying!!

Slash65

iTrader: (8)

My painting skills are well below par with some of the bodies I have seen on this thread. Would anyone be willing to paint one for me at a reasonable rate?

If so PM me with an estimate...

tedstryker

iTrader: (88)

which Traxxas pillow ball spacers are you guys using...

thecman26

iTrader: (112)

For me there's no real "need", I just had one laying around!
So I just threw it in! With a 16t pinion it was barely warmed up!
I have a 540 6.5 laying around too but dont want to have to use
That annoying pinion adapter....

But even under geared it was insane fast!
But seriously the truck is a TON of fun to drive and is very stable!
If I can calm down the steering it would be awesome!
Its really twitchy right now, just need to turn down the steerin expo a bit
On my radio.